Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Variable speed adjustment

Posts

Variable speed adjustment

#1

Variable speed adjustment

Thomas Cline

>I have a 1954 model Wadkin lathe with 3 phase motor and was curious if I can install a variable speed control within this electrical configuration? To change the speed you must slide a leather belt around on pulleys. Thanks

Re: Variable speed adjustment

#2

Re: Variable speed adjustment

Pete in Holland, MI

>The three phase motor is the right motor for a frequency drive. Many high end lathes come with these "freq" drives, and are set up to be fed with single phase power.

Yes, they're out there, but I don't know where to point you to get one. They aren't cheap, so be ready to shell out some cash to get one.

Pete

Re: Variable speed adjustment

#3

Re: Variable speed adjustment

john lucas

>A variable frequency drive will work with your 3 phase motor and will give you variable speed. I have installed several but I don't have the electronic background to tell you what controller to buy with what motor.

One place to get them is www.dealerselectric.com.

Re: Variable speed adjustment

#4

Re: Variable speed adjustment

Gary Evans Tallassee, TN

>Hi Thomas,

I had good luck buying a 3 HP variable frequency drive off e-bay. I think I paid $150 for it. There are usually several on there, many of which are just last year's model. I did a lot of research on the manufacturer's websites for the various units on auction and evaluated the best unit for the price.

Maybe I was just lucky, but I feel there are some good units out there for a reasonable price if you are willing to do a little comparative shopping.

Gary

Re: Variable speed adjustment

#5

Re: Variable speed adjustment

gtwilkins

>Thomas,

You have to match the variable frequency drive (VFD) to the motors horsepower. Basically the VFD takes single phase power (either 110 or 220 volts) and electronically powers the 3 phase motor.

http://www.leeson.ca/Html/Products/adjspeed.htm

I used a Speedmaster SM Series VFD and a 1hp 3 phase motor on my Shopsmith before I ungraded my lathe.

With the VFD I used I had to purchase an on/off push button switch and a controller to adjust the speed. It did take me a while to figure out the programming for the VFD but it was fairly simple once I got started.

I then had preset speeds, or I could manually ramp up the speed, dynamic braking so I didn't have to wait for the lathe to coast to a stop plus it gives you more torque at lower speeds.

Hope this helps, Trevor

Re: Variable speed adjustment

#6

Re: Variable speed adjustment

Bill Hale / The Wood Spinner

>Check out this site.

www.surpluscenter.com

They also have great tech people if you give them a call. If you call be sure to have all the info on the motor you have.

You will never be sorry you got a variable drive.

Good turning and be safe

Bill in CG, AZ.

Re: Variable speed adjustment

#7

Re: Variable speed adjustment

Thomas Cline

>John, Thanks for the information about Variable Speed Controls. Called dealerselectric and they fixed me right up. Technology has come a long way. Thanks Again Tom C.