Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

jumbo jaw building question???

Posts

jumbo jaw building question???

#1

jumbo jaw building question???

keith zimmerman, Normal, IL

>I am going to build a set of jumbo (cole) jaws for one of my Talon chucks and have found all the parts. The body of the jaws will be made from a sheet of phelonic I have and I plan to use rubber stoppers to hold the bowl.

My question is: what size rubber stopper should I use? They range in size from 8mm to 55mm in diameter. I am thinking that 10mm would be more than adequate for my purpose. These jaws will be used on a Jet mini, so the jaws will only be about 8" in diameter.

keithz

Re: jumbo jaw building question???

#2

Steven Antonucci

8" Jumbo jaws?

steve antonucci

>Why not make a "stepped" jaw out of MDF? Basically a circle cut in quarters with some accurate drilling for the screws? probably get away with no more than 3 steps and no bumpers...

Steven

Re: jumbo jaw building question???

#3

Re: jumbo jaw building question???

Rick Davenport

>You can get a bumper replacement kit for standard cole jaws.

Oneway uses black rubber, which I have, but I'm thinking those square red ones they have for vicmarcs might be better.

Check out Craft Supplies, I believe they stock both.

R

Re: jumbo jaw building question???

#4

Re: jumbo jaw building question???

Bill Clark

>I have both and prefer the Vicmark red square bumpers.