Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Wood Guru Help Needed

Posts

Wood Guru Help Needed

#1

Wood Guru Help Needed

Ken OakleyWarming Up St. Cloud, Fla.

>A friend of my son in law works for a tree cutting/removal company and knowing I cut various woods into pen blanks for sale on Ebay he contacts me whenever they cut a tree he feels I could use for that purpose. Today my SIL stops and said his friend called and said they had just cut down an Elm tree. Did I want some logs.

Can't remember ever working with or seeing elm. I said OK.

It is very heavy so I assume it is hard. How does it machine, especially turn on a lathe? Any info or advice would be much appreciated. Remember this is Florida so Elm here may differ some from ,say Michigan.

Re: Wood Guru Help Needed

#2

JL

Re: Wood Guru Help Needed

JL

>A friend of mine (Jim C.) has made a chair and a settee out of American Elm (think his was gray Elm). Hard wood, takes a very crisp line - his baluster legs were quite nice. Machines well but he said it was tough on his tools so he had to sharpen them often. So, if you don't want it, I'll come and get it :).

Re: Wood Guru Help Needed

#3

Re: Wood Guru Help Needed

Bill Clark

>I did a couple of bowls out of some freshly cut Chinese Elm harvested here in Calif. The wood was very heavy, tough, dulled my bowl gouges very quickly and looked a lot like Ash with deep pores. This variety would not be my choice for pens.

Re: Wood Guru Help Needed

#4

Re: Wood Guru Help Needed

Clay Foster

>Ken, I've worked a lot with three kinds of elm that grow here in north Texas. They are all attractive wood, hard and very efficient at dulling tools when dry. Cedar elm here has a red heart and white sap wood. It's not easy to work, but I like the way it looks. American elm here is mostly white, but can spalt nice. Piss elm smells like the bathroom floor of a tuna boat.

Re: Wood Guru Help Needed

#5

Re: Wood Guru Help Needed

Ken OakleyWarming Up St. Cloud, Fla.

>See photos I posted on Message Board. It has been identified as Chinese Elm.

Re: Wood Guru Help Needed

#6

Re: Wood Guru Help Needed

Nick

>I've made end grain turnings in elm (white), red elm and siberian elm, all from the midwest. The white-colored (sapwood, I guess) elm is very hard and looks good on the end grain where there is a lot of contrast. It might look good dyed, too, but I've not tried it. Red elm is softer and the spring wood rings are almost punky or powdery. You would probably need to fill the grain to get a good finish. I don't care much for the stuff. Siberian elm seems to be somewhere between the other two. I doubt that plain white elm would make a good pen unless you figure out some way to make the wood look more interesting. Good luck

Re: Wood Guru Help Needed

#7

Re: Wood Guru Help Needed

Bill Clark

>Yep, after looking at the pictures of the wood, leaves and bark it's a dead ringer for the Chinese Elm I used.