Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Green Wood Turnig

Posts

Green Wood Turnig

#1

Green Wood Turnig

Thomas Cline

>I have had oppotunities to aquire lots of great turning wood but am concerned that when I cut up the logs into chunks, that I can handle, they may dry out too much before I can turn them. How do you store these 'chunks' and how long can they sit before they will loose the good green turning ability. Do you treat the ends?

Thanks for your replies.....

Re: Green Wood Turnig

#2

Re: Green Wood Turnig *LINK*

Mike Cunningham (Cape May NJ)

>You could leave them in log length cutting off blanks as you need them, always having to cut away a bit of checked and cracked ends or you could process them into blanks. Cut them to a length equal to the width (for bowl blanks), then cut them lengthwise eliminating the pith (center of the log which is where your cracks originate) with two cuts on either side of the pith. The using anchorseal or another sealing product (in a pinch use latex paint) seal the end grain and place them out of the weather. Outside is okay but keep direct rain and sun off of them.

Go to Bill Grumbine's website, he has a tutorial on processing a log, at least he used to...see the link

Mike


Wonderful wood

Re: Green Wood Turnig

#3

Re: Green Wood Turnig

Thomas Cline

>Thank you Mike. How long do you think they will keep "green" say with latex paint on the ends? Tom

Re: Green Wood Turnig

#4

Re: Green Wood Turnig

Mike Cunningham (Cape May NJ)

>Depends on the wood, some is more forgiving than others. Fruitwoods can deteriorate quickly. I'd process it as described and get to it as quickly as I could rough turning it.

Re: Green Wood Turnig

#5

Re: Green Wood Turnig *LINK*

JohnKJordan in East TN

>A recent thread discussed this, link below.


preserving blanks thread

Re: Green Wood Turnig

#6

Re: Green Wood Turnig

Allen Neighbors

>Some really good advice on this thread. I can only add this: If it's fruit or nut wood, I'd saw it into blanks as soon as possible, and then I'd coat the entire piece with Anchor Seal or paraffin, and store it in a closed container, like an old refrigerator. Then I'd rough turn it as soon as I had the time. Open the door for a few minutes every day, just to allow a little circulation of fresh air for damp.