Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

new trick

Posts

new trick

#1

new trick

john lucas

>I often need to drill a hole in a box lid for the knob or finial. I've usually drilled all the way through but then I have to decorate the inside. It's hard to drill a really shallow hole because of the drill points. So you end up turning the hole which is time consuming.

Today I pulled a milling cutter out of my metal lathe tool box and used that. Perfect. It cuts a fast accurate hole that has a perfectly flat bottom. I think a straight router bit might work as well. I'll try that later when I get time.

Re: new trick

#2

Re: new trick

Barry Irby

>Thanks John, Yet another solution. I have used Forsner bits and brad point bits, but not an end mill. (Don't have a metal lathe, but for some odd reason I have one end mill and don't know whence it came.)

Re: new trick

#3

Re: new trick

Carol - now in NC Nebraska

>I've used end mills for routing for years, Barry. That ring a bell?

Re: new trick

#4

plunge router trick

jwoodwright

>John Lucas - some folks use a plunge router and straight bit with a piece of peg board to make shelf holes for the supports.

Makes nice clean flat bottom holes...