Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Help needed fixing dimples

Posts

Help needed fixing dimples

#1

Help needed fixing dimples

Dinyar Chavda

>When hollowing a piece, I find it relatively easy to fix any ridges that might exist inside the piece. However, I find it much more difficult to get rid of dimples or valleys.

While I can feel it with my finger, I find it very difficult to locate it with the hollowing tool (almost regardless of whether it is a Hunter, ProForme, Kelton, or scraping bit), or whether I am using a straight shaft or a swan-neck, and get rid of it.

Any suggestions?

TIA

D

Re: Help needed fixing dimples

#2

Steven Antonucci

With the lathe off...

steve antonucci

>Insert your tool until it's in the dimple. Using your fingers to mark the shaft where the tool is when it's on the dimple, pinch the shank. Think of your fingers acting like a stop collar to limit going past the point, and just manage the gap from the entry to your fingers to limit the other side of the cut.

In addition, cut from the top to finish dimension and NEVER go back and take "one more cut", unless you like blowing up wood (like me).

Clear as mud right?

Steven

Re: Help needed fixing dimples

#3

Re: Help needed fixing dimples

john lucas

>I have the same problem. My best attempts are by taking really light cuts back and forth about an inch or so. I used to use a larger scraper type cutter figuring that it covered the gap and took off the high spots. This works OK on vessels you can't see in but vessels like vases it causes too much tearout so you have to sand too much. Light cuts with the Hunter tool or ring tool have helped on these vessels.

Re: Help needed fixing dimples

#4

Re: Help needed fixing dimples

Lan Brady

>Dinyar,

I use a 1" sanding pad on a long shaft.

In the drill, it takes off the nub real quick. I have never made a valley so I don know how to remove that.

Good Luck, Lan

Re: Help needed fixing dimples

#5

Re: Help needed fixing dimples

Carole Valentine

>I find that a high speed and very light cut does it. You should feel the bit cutting on the near side of the valley, not cutting as it goes over the valley, then cutting again when it gets to the other side. Don't let the bit go into the valley or you just make the problem worse. Speed helps with this. I locate the valley with the tool with the lathe OFF, then start the lathe and make a sweeping cut to pick up some wood before the valley and continue on until I've crossed it. You need to feather the beginning and end of these cuts or you will end up with more ridges or valleys.