Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

General 260 Lathe Question

Posts

General 260 Lathe Question

#1

General 260 Lathe Question

Marvin Horn

>I'm an occasional turner, mostly to support flatwork I do, but do turn the odd bowl. I few years ago I picked up a General 260 with the Reeves varible speed drive and really love it. The drive was really poorly adjusted when I got it but tuned up nicely and has run flawlessly since. Only "improvement" made was a reversing swith on the motor for sanding.

Now my question. What are the Pro and Cons of the Reeves Drive vs. an Electronic VSD? Most VSD's include step pulleys to keep you in the motors best operating range (cooling, torque ect.). The Reeves never has to to be adjusted. Speed range on the Reeves is adequate and can be shifted somewhat in setup towards bowl or spindle turning. I've never stalled the lathe hogging off a bowl. Am I missing something?

Re: General 260 Lathe Question

#2

Re: General 260 Lathe Question

Allen Neighbors

>The only thing that I didn't like about my old lathe's Reeves Drive was that I couldn't get the speed down slower than about 350rpm. I think that's the biggest problem you'll hear about. If they had made it with a larger pulley travel distance, it would have slowed down more.

I think the next biggest problem is the bad design of a lot of them, using inferior materials, and poor workmanship in putting them together. It's also hard to keep most of them clean enough for smooth operation.

Your drive on the General is probably a very well made system.

Re: General 260 Lathe Question

#3

Re: General 260 Lathe Question

Wally Dickerman

>I had a General 260 with a Reeves drive for about 10 years. Before that I had a Delta with Reeves drive. The Delta drive was lousy...The General was very good. Never had a problem that I can remember, and I turned hundreds of pieces on it. I did a lot of turning on the outboard side...left handed threads...for my hollow forms. I sometimes wished for a slower minimum speed, but actually that was seldom a problem. A well made lathe.

Wally

Re: General 260 Lathe Question

#4

Re: General 260 Lathe Question

robert davis

>one of my lathes is a 160 genersal about 11 years old. i slowed the low speed by using a smaller motor pulley. though i have anova 3000 with dc variable drive..stilluse the general. dc is more versatile but the reeves still works fine. canadian made general products are quality. dont know about the newer general international.

Re: General 260 Lathe Question

#5

Re: General 260 Lathe Question

ET

>One advantage is full power to the spindle at all times. ie. the motor always runs at full speed (1750 rpm ) and delivers full power. I have a 1 HP mptor on my 260 VS and have never been wanting for more. There is no loss of power as the speed is reduced. That is why turners with the electronic VS versions want a 2 or preferably 3 HP motors.

There is no comparison between the General 260 reeves and anything else that calls itself a reeves drive. The General is all machined pulleys with a special wide cogged belt. There is a zirk grease fitting on the side of the idler system to allow the occasional regreasing of the sliding sheave. Be sure to grease yours once in a while. ET