Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Temporarily filling a void Question.

Posts

Temporarily filling a void Question.

#1

Temporarily filling a void Question.

Barry Irby

>I have a piece of sycamore that is just a little past spalted. It has a void in the end grain in one of those interesting and vaguely star burst shapes that Mother Nature gives us once in a while. I turned a hollow form out of the sister piece and lost some of the detail in the shape of the void. I tried driving pieces of wood into the sections and that helped. I also soaked it with CA. I want to turn the second piece and was wondering if there ls some way to fill the void while I turn it and then remove the filler later?

Re: Temporarily filling a void Question.

#2

Re: Temporarily filling a void Question.

Stuart Johnson

>If the void is very irregular could you place a piece of plastic wrap over the void and then pack it with Bondo? I think the wrap would prevent the Bondo from sticking and the void might work to lock it in place. After turning it should be easy to remove the Bondo with a Dremel.

I have no idea if this idea will work or not.

Re: Temporarily filling a void Question.

#3

Re: Temporarily filling a void Question.

eaglesc

>Not sure of the size of the piece or the configuration of the void but after turning CA can be removed with acetone. THe Aceton will soften the CA so it can be "picked out".I don't know if this will help but I thought I would offer it.

Re: Temporarily filling a void Question.

#4

Ice

Rick Allen

>Fill the void with water and freeze it hard. Turn the shape quickly while there is ice and not water.

Re: Temporarily filling a void Question.

#5

Re: Temporarily filling a void Question.

JohnKJordan in East TN

>Yikes, be careful. Seems like filling with something heavier than wood and not securely bonded might cause an imbalance and some pain if it flys out.

Re: Temporarily filling a void Question.

#6

Re: Temporarily filling a void Question.

john lucas

>Barry unless the piece would fly apart due to the void I wouldn't do anything. Just increase the lathe speed and be light on the bevel and you can turn right over a void.

If you think it might be unstable turn the outside. Then wrap straping tape around the outside and turn the inside. The straping tape will keep it from blowing up. Wrap the straping tape in the direction the bowl is turning or it can catch the wind and undwind very rapidly. don't ask how I know this.

Re: Temporarily filling a void Question.

#7

Re: Temporarily filling a void Question.

John Veerkamp

>Barry,

for a temp fill use plaster of paris. It will be easy to remove later. I would also reinforce the outside with tape as suggested. I use cheap vinyl electricians tape.

John