Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Writing on your turnings

Posts

Writing on your turnings

#1

Writing on your turnings

Mark McC

>Made a couple of Wine bottle shaped Pepper mills for this years wine gift baskets. I was thinking about writing something on the label area of them.

I obviously want to try and find something that won't be disturbed by the finish once I apply it

Any suggestions as to what sort of marker or pen to use i.e Sharpie?

thnx

M.

Re: Writing on your turnings

#2

Re: Writing on your turnings

Keith Inscho E. Tenn.

>I have been using a Prismacolor Premier fine line marker. Size .01 mm. Makes a super fine line and holds up to finish pretty well if it is good and dry.

Re: Writing on your turnings

#3

Re: Writing on your turnings

Bill Hale / The Wood Spinner

>I usr the Pilot V Razor Point extra fine and it works great.

Be sure the area you write on is dry or the ink will wick. Give it a few minutes to dry and finish over it.

Good turning and be safe

Bill in CG, AZ

Re: Writing on your turnings

#4

As usual, test before you put it on your work

Bill Howatt

>

Re: Writing on your turnings

#5

Re: Writing on your turnings

Brian Hahn in SW Wisconsin

>I like a "Micron" pen. It is an archival ink that is permanent when dry and it is not affected by finishes. These pens are usually found in either the ink drawing or the scrap booking sections of art and craft stores.

Wicking can be minimized by sealing the wood first with a light coat of finish, then sanding it back to the bare wood so the ink will stick.

I've had trouble with Sharpie and Prismacolor pens bleeding under various finishes and they both will fade with exposure to sunlight.

Re: Writing on your turnings

#6

Dick Hines

Re: Writing on your turnings

Dick Hines

>If the turning is large enough I burn my name date and type of wood on the bottom. I have altered the tip like Dick Sing does. It is makes a very fine tip. If the piece is to small to burn I will use a .01 pen.

Re: Writing on your turnings

#7

jim miles

Re: Writing on your turnings

jim miles

>I use a fine point sharpie. I finish most pieces with spray lacquer. The lacquer will dissolve the ink. I keep a small bottle of water base poly to coat the bottom after I sign. It will seal it and then you can put other finish over it if you want

Re: Writing on your turnings

#8

Re: Writing on your turnings

BobM

>I use a Sharpie fine tip to sign turnings and that works well.