Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

lathe tool stand

Posts

lathe tool stand

#1

lathe tool stand

James Pittman

>Help!! I saw the plans for a round revolving lathe tool stand in a woodworking magazine. I have started in woodturning and would like to build one,but I can not find the mazagine.Does anyone know which one it was in,or do you have a plan for one? Thanks Preacher

Re: lathe tool stand

#2

Re: lathe tool stand

Dick Mahany

>Not from plans but here is one I made that works well. Has a lazy susan bearing and was simple to build. If I had to do again, I'd size the holes for handles a little larger as some larger handles don't fit.


img

Re: lathe tool stand

#3

Re: lathe tool stand *LINK*

Mike Brazeau

>Here are a couple of things I did four years ago and am still happy with them. I have made some additions in fact for storage of Oneway Coring set and various tool rests etc.


Tool storage solutions

Re: lathe tool stand

#4

Re: lathe tool stand

Peter Hyde

>This one was built from baltic birch and has a lazy susan bearing in the base. My own design and I can provide some measurements if needed.


img

Re: lathe tool stand

#5

Very Nice but all I can think of is "Bandades"

Wayne

>

Re: lathe tool stand

#6

Re: The three I've seen on this post....

Allen Neighbors

>are all well done gentlemen! Thanks for posting them. As soon as I locate a small rolling table I'll use one of these for the top of it. I need a small one to use right next to whichever lathe I'm on.

I have a large rolling stand that I made from an old Ambulance Gurney, and it holds all my tools, and accessories, but it's too large to roll around in a crowded shop, so I move it once for the Winter months, and once for the Summer. :)

Re: lathe tool stand

#7

Re: lathe tool stand

Bob Macgregor

>I've had a couple of close calls (as in non-bleeding cuts!) reaching past a sharp tool to grap another. Is that a problem with the carousel...especially with additional tools in the middle?

Re: lathe tool stand

#8

Re: The three I've seen on this post....

Carole Valentine

>Allen, I have one of those hospital bedside tables that patients use for their meals. I am going to make a tool caddy out if it. It should be perfect - rolls around easily, adjustable height. Even has a small drawer. Our local hospital was getting new stuff so they just threw all of the old stuff away. I should have gotten a couple of the three drawer nightstands on wheels but at the time, that stuff was not on my list of priorities.

Re: lathe tool stand

#9

Re: Those would be great!!

Allen Neighbors

>The rolling tables, I mean. Well, both of them, actually, Carole. When our hospital gets in new equipment, I grab some of the old rolling IV stands. They make good stands for clip-on lights.

I'll have to keep my eye out for some of those rolling bedside tables.

Thanks for the hint.

Re: lathe tool stand

#10

Re: Spin it around, and keep

Allen Neighbors

>the outer tools separated enough to allow you to reach past. :)