This is Barry Irby's fault...
GaryG in MD
>Barry evoked Bill G. in the Dust Collector (see:
http://www.woodcentral.com/cgi-bin/turning.pl?noframes;read=166983&v1=e2vrt43&v2=Rockler&v4=Porter+Cable+tool&v5=nx3we6g ),
so here it is.
Knowledge You Can Build On — Est. 1998
This is Barry Irby's fault...
GaryG in MD
>Barry evoked Bill G. in the Dust Collector (see:
http://www.woodcentral.com/cgi-bin/turning.pl?noframes;read=166983&v1=e2vrt43&v2=Rockler&v4=Porter+Cable+tool&v5=nx3we6g ),
so here it is.
and now the image...
GaryG in MD
>
with thanks...
GaryG in MD
>...to my friend of over 50 years, author and cartoonist, Steven D. Fisher, from Bismarck, ND. Cheers. ...Gary
Very funny
john lucas
>I assume the chute is Stainless Steel? :)
Dust collector on steriods *LINK*
Ron in Drums PA
>I saw one of these pick up a 16lb bowling ball. In the upper right image they are picking up 2"-3" river stone
BTW - great drawing Gary
Hurricane Vacuum
Re: This is Barry Irby's fault...
Bill Grumbine (Kutztown PA)
>You laugh. I have a DC setup almost exactly like that by the lathe. Of course, if it was going to suck me up, the shop would probably implode in the process. There would be a big BANG and then nothing where the shop used to be except maybe the slab it sat on.
Bill
Re: Dust collector on steriods
Bob Macgregor
>I never realized a cyclonic separator could be left open-ended like that. I don't think even Bill cuts chips as big as bowling balls, so this should do the job. Maybe it would suck hard enough to catch a flying bowl before it goes through a window! A skeet-sucker instead of a skeet shooter?
That would be the big bang theory
john lucas
>
Re: This would prove the existance ......
Jamie Donaldson
>... of "black hole" theory in the turning studio!! But I can't envision any vac system that could lift Big Bill off the floor!!?? ;-)))