Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Milwaukee Angle Drill Brush Replacement

Posts

Milwaukee Angle Drill Brush Replacement

#1

Milwaukee Angle Drill Brush Replacement

Ed McDonnell

>I can't find a copy of a tutorial I had on replacing the brushes on a Milwaukee Angle Drill (0375-1 / 611B). Google has been no help tonight either. Anyone know of any online how-to's?

I seem to remember there were a couple tricky steps to disassembling / reaseembling, but can't recall the details. I hate to learn the hard way.

Ed

Re: Milwaukee Angle Drill Brush Replacement

#2

Re: Milwaukee Angle Drill Brush Replacement

Dave Peebles Lyons, Ohio!

>Hi Ed,

I think it was Terry Daniel that posted a very good tutorial on this subject on this very site.

You might want to do a search or contact Terry directly.

Best wishes,

Dave

Re: Milwaukee Angle Drill Brush Replacement

#3

the article was about bearing replacements, I thin

Michael Stadulis, in Gloucester County, NJ

>

Re: Milwaukee Angle Drill Brush Replacement

#4

Re: Milwaukee Angle Drill Brush Replacement *LINK*

George Van

>Ed, I did a search at the link below for Milwaukee drill and all the articles came up. Hope this helps.


WoodCentral Archive

Re: Milwaukee Angle Drill Brush Replacement

#5

Re: Milwaukee Angle Drill Brush Replacement

Darryl

>Ed the Milwaukee web site has the schematic for the drill. If you need it I have a copy that I can send you. The brushes are not that difficult it is the wiring placement that is troublesome. the schematic covers that as well.

Re: Milwaukee Angle Drill Brush Replacement

#6

Duh... you are right Michael.. sorry

Dave Peebles Lyons, Ohio!

>Hi Michael,

I guess I just channeled that most problems are with the bearings. :)

Best wishes,

Dave

Re: Milwaukee Angle Drill Brush Replacement

#7

Re: Milwaukee Angle Drill Brush Replacement

Ed McDonnell

>Thanks for all the replies.

I finally figured out why search wasn't helpful the other night. I didn't change "any" to "all" and I got thousands of responses that had nothing to do with milwaukee drills.

I also eventually managed to find the wiring diagram online which contained a warning about wiring paths, which I think is the tricky part I sort of remembered.

Anyway, I had thought I had a brush problem because of all the sparks and a stuttering motor. After disassembly it turns out it is the ususal suspect on these drills, the bearings.

Looks like I'm on the right track to repair now.

Thanks again.

Ed