Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

How long would you wait?

Posts

How long would you wait?

#1

How long would you wait?

Mark in Whitby

>Looking for some experienced turner advice here..

I am just an occasional spindle turner.

I am working on some maple spindle turnings that have an inserted block of cherry glued into the Maple blank using yellow glue.

How long do you think I should wait before turning?

I know the glue usually sets up in an hour and half, but when will it be strong enough to turn safely?

thanx

Mark

Re: How long would you wait?

#2

Peter Charles Fagg (UK)

Re: How long would you wait?

Peter Charles Fagg (UK)

>My immediate thought was "which glue are you using" and "What is the recommended time period for use" according to the manufacturer?

If it is PVA I would suggest that for safety's sake to leave the pieces for at least 24 hours. If that is deemed excessive, rather that than have the pieces fly apart.

Regards, Peter.

Re: How long would you wait?

#3

24 hours

Cyril Griesbach

>

Re: How long would you wait?

#4

Re: 24 hours

john lucas

>I've turned things in as little as an hour using PVA glues. That depends a lot on how comfortable you are with your joinery. If you have a gap free joint and use the right amount of pressure you should be alright. For larger projects I prefer the safety factor or overnight. Segmented bowls and larger stave projects I always wait until the next day to turn. That's probably 12 to 14 hours. Haven't had a failure yet.

The only glue problems I've had were on inside out turning where I used a paper joint. I suspect the paper slows the drying time down a little. I blew up a few when I was using my 1 hours drying time. I started waiting overnight on those and haven't had a problem.

Re: How long would you wait?

#5

Re: 24 hours

Steve Mushinski

>Second the paper joint needing a full cure time. I found out the hard way. Good thing for face shields.