Re: New platter
Rick Allen
>There are a few things I would consider. Ray Key says that flamboyant wood doesn't need fancy turning details. He say to save those details for more plane timber.
Another curious thing is that features done in odd numbers are better than even numbers. So instead of 2 beads 3 beads or 1 bead would work better. I don't know why this is but I know I have "tested" this rule of thumb and have found odd to work better than even.
You have 4 features on that platter.
1. The outer rim bead
2. The rim to body interface of 2 beads
3. The raised portion of the middle
4. The flame figure of the wood
If you have a lot of features I have found that they should complement each other. All the beads the same size or the beads getting progressively smaller or larger. Mostly I like to leave it at just one turned feature and one wood feature. To many disparate features tend to confuse the viewer.
On this particular piece of wood I would consider a simple curve from the rim to 1/5 to 1/4 of the way in with the remainder flat across the bottom. That would really show off the flame figure. There are some options for the rim edge to show off some detail. You could also show off detail on the back side of the platter.
Walnut bleaches really well. So burning a design in the rim area that is then bleached and colored could make quite an artistic statement. Perhaps some hot rod flames around the rim to complement the flame figure in the wood.
The best thing about all of this is that you get to make whatever you make of the hunk of wood. And whatever you make is going to have an impact on the viewer.