Talon chuck and oneway 2436
john lucas
>A friend asked me if the talon chuck has an adaptor to fit the 2436. I don't own either and the Oneway site is down so can anyone answer that question.
Knowledge You Can Build On — Est. 1998
Talon chuck and oneway 2436
john lucas
>A friend asked me if the talon chuck has an adaptor to fit the 2436. I don't own either and the Oneway site is down so can anyone answer that question.
Re: Talon chuck and oneway 2436
Allen Neighbors
>The Talon is a Oneway Chuck. I can't believe they would make a chuck that didn't attach to all their lathes. My 1640 has an M33 spindle, and they have an adapter for that, so I'll bet they do.
I didn't buy one... I just checked them out before I bought the Titan. I had thought that the Talon was a large chuck, but found out it wasn't. :)
Re: Talon chuck and oneway 2436
Dennis Daudelin
>Yes, there is an adapter to use the Talon on the Oneway. But the talon is a small chuck so it's good for small blanks. If you're planning on using the bulk of the 24" swing, then you're really going to want to use the Stronghold chuck.
I use both on my 2436 and almost always have the spigot jaws on my Talon. They are great with square stock, you can pop it in and start your spindle turning without have to put it between centers and make you round tenon.
Good luck,
Dennis
Re: Talon chuck and oneway 2436
john lucas
>Thanks Allen and Dennis. I was able to get into their website and confirm that they do make spindle inserts for the Talon to fit the big Oneway. My friend already has the big chuck but wanted a smaller one.