Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

new turner questions

Posts

new turner questions

#1

new turner questions

Brent

>Guys, I'm looking at laminating a light colored wood with walnut and turning it. Any suggestions? I know poplar and holly are both roughly the color I'm looking for, but I also know they aren't really that hard - how will they turn when glued to walnut. Thanks for the input.

Brent

Re: new turner questions

#2

Steven Antonucci

I'd use maple

steve antonucci

>I think it's the "norm" and can be almost as white as holly.

Steven

Re: new turner questions

#3

Re: new turner questions

Mike Cunningham (Cape May NJ)

>I often laminate walnut, maple and cherry; as well as padauk, maple and walnut. I've also done bubinga, maple and walnut. All worked fine together.

Mike

Re: new turner questions

#4

Re: new turner questions

Brent

>Thanks guys - if my ideas make it into reality, I'll share them here.

Brent

Re: new turner questions

#5

Re: new turner questions

john lucas

>I try whenever possible to use woods of approximately the same hardness when I do segmented or laminated work. Maple and Cherry are about the same. Holly is as hard as cherry. Walnut, Mahogony, Poplar are somewhat similar. This is not a hard fast rule it just makes sanding easier because the woods will sand about the same. If you put a real hard wood next to a soft wood the soft wood sands faster and you can get lumps if your not careful. the trick of course is to turn as clean as possible and then sand with a fairly hard backing to keep the ripples out. The more skilled your turning the more you can get away with when using dissimilar woods.

Re: new turner questions

#6

Re: new turner questions

eaglesc

>You didn't say how large of a glue up this will be.

Depending on the size of whatever you are turning, adding CA will"equalize them".

I mix all kinds of woods, grains in any direction.

CA is also a good sealer to prevent color migration between dark and light woods.

Re: new turner questions

#7

Re: new turner questions

JohnKJordan in East TN

>>I mix all kinds of woods, grains in any direction.

>CA is also a good sealer to prevent color migration

>between dark and light woods.

Eagle, do you have a favorite type of CA for this? Do you soak the pieces then wipe it off or apply it thin?

I've been using CA more on small turnings lately, to seal pores and under other finishes.

JKJ