Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Stoppersd with SS Niles cones

Posts

Stoppersd with SS Niles cones

#1

Stoppersd with SS Niles cones

Mike Cunningham (Cape May NJ)

>Pictured are some of the 120 stoppers I recently turned. Last year I moved from the chrome cones to Ruth Niles SS and the difference is night and day. I highly recommend her product.........her tee shirts too!

Mike


img

Re: Stoppersd with SS Niles cones

#2

Re: Stoppersd with SS Niles cones

Tim GC

>Mike,

I like the forms and finish. As I am about to start my first attempt at stoppers with a run of 10, I should like to refer back to these, if you do not mind. But I must ask what wood is the 2nd on the left please?

Tim

Re: Stoppersd with SS Niles cones

#3

Re: Stoppersd with SS Niles cones

Mike Cunningham (Cape May NJ)

>Hi Tim,

It's either bocote or zebrawood, I do not recall, probably the former. The finish is 3 coats of watco and Beall buffed. They're just simple shapes in low profile to answer to those that may say "But they won't fit in the refrigerator". I also do them a bit taller but keep them simple as well, mostly a round top with a few coves and beads, not too fussy.

Mike

Re: Stoppersd with SS Niles cones

#4

question, Mike...

GaryG in MD

>How heavy are your 3 coats of Watco? Does this end up filling the pores or do you get something akin to my photo below (in my answer to Mike Stafford in the "end-grain finishing" post)? These look nice. I'm wondering if I'm wiping my Watco off too quickly. Thanks, Gary

Re: Stoppersd with SS Niles cones

#5

Re: question, Mike...

Mike Cunningham (Cape May NJ)

>Hi Gary,

I don't get any kind of pocking or open pores, just a smooth finish. On stoppers I sand to 1000 (probably don't need to go that fine) and apply 3 coats of watco. All coats are heavy, in other words the wood is thoroughly wet. I leave it wet for a half hour or so, then wipe it. Sometimes the initial coat is absorbed quickly in which case I apply more. I allow 24 hours between coats and buff after the third and final coat has dried for about one week. There have been times that I've buffed sooner. I use all three Beall wheels.

Maybe you need better surface prep, perhaps sanding to a finer grit or allowing more time before buffing.

I don't know that these stoppers will show up any better than the others.


img

Re: Stoppersd with SS Niles cones

#6

Re: question, Mike...

Ruth Harding

>They are really nice Mike! When you make so many do you repeat the design with a set frequency or just as the turning takes you? When you say Beall buff, do you mean the three steps or just the waxing?

thanks,

r

Re: Stoppersd with SS Niles cones

#7

Re: question, Mike...

Mike Cunningham (Cape May NJ)

>Hi Ruth,

No set way of doing them, just sort of a come what may. I do however make a point of turning so many low profile and so many taller.

Yes, three step Beall.

Mike

Re: Stoppersd with SS Niles cones

#8

Re: question, Mike...

GaryG in MD

>Thanks Mike. I'll try both the finer sanding and the heavier coats of Watco. One or both should do the job. ...Gary