Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Salad Set for Christmas Gift

Posts

Salad Set for Christmas Gift

#1

Salad Set for Christmas Gift

Jerry Hall

>The Black Oak was piling up, and my sister up in Washington state loves her oak furniture and knickknacks. I turned a 5x12 salad bowl earlier, but yesterday had an idea to make some multi axis handled serving set. So here is the result.


img

Re: Salad Set for Christmas Gift

#2

Re: Salad Set for Christmas Gift

Cyril Griesbach

>Very nice, Jerry, I'm sure she will be delighted.

Re: Salad Set for Christmas Gift

#3

Great job!

Mike Cunningham (Cape May NJ)

>

Re: Salad Set for Christmas Gift

#4

Re: Salad Set for Christmas Gift

Allen Neighbors

>How nice! Those surely ought to get you some points with Sis!! Well done. :)

Re: Salad Set for Christmas Gift

#5

Re: Salad Set for Christmas Gift

Ed Larson

>Jerry, great job. Are the salad tongs Oak also??

Re: Salad Set for Christmas Gift

#6

Steven Antonucci

Love the salad servers

steve antonucci

>Very well done. Are they exclusively turned or were they also worked off the lathe?

Steven

Re: Salad Set for Christmas Gift

#7

The wood and the process

Jerry Hall

>The spoon and fork are oak also. I had it labeled "Valley Oak" but who knows. The blank was about 3 x 16. Cut into a long "T" with the handle about 1-1/2 square.

- Put as much of the handle as I could into 2 jaws of a big Vicmarc long nose chuck.

- Rough turned the handle and made a pommel at the spoon,fork end between centers

- turned the bottom 40% on center

- turned most of the top angled off center to create an angle that seemed suitable for an implement

- turned the end on a third angled center to create a comfortable way for it to nest into the palm of my sisters hand, and for interest. Made the two ends different so my sister could tell the difference between a fork and a spoon (: Don't tell her I said that.

- Used a French curve to layout the shape I wanted, band sawed and cleaned up with a stationary belt sander. Hand sanded. Watco. Then walnut oil after full drying to maintain.

I did "flat" work for the spoon end so I could preserve the mass for tail stock support while changing centers. May experiment with smaller scale fully turned items. Should be doable off center to create a shallow curve within the spoon/fork. But it wouldn't be any faster, and I am not sure it would be a better design.

It felt good to have an idea at the end of the day, just before cleanup, and then have it turn out so quickly.

Thanks for all your comments.

Re: Salad Set for Christmas Gift

#8

Very nice... great work

Randy G

>