Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Training bar for a Hunter tool?

Posts

Training bar for a Hunter tool?

#1

Training bar for a Hunter tool?

Eddie Pacheco; San Jose, Ca.

>I made some time, the past few days, to do some turning on some wet and dry wood chunks that I have. I used the Hunter #3 mounted to my former Termite handle on most of the pieces. On a piece of wet wood, that I was using the tool for spindle type turning, I got the Hunter cutter flat as it approached the wood and it's aggressive cutting action provided a self feed, into the wood, until past the c/l of the cutter and then BAMM! a nasty catch. It happened fast. I have also done this mistake on end grain work and the result is also a launched bowl.

Today I drilled a piece of bar stock and created this hefty outrigger to help me control the tool. It worked out well for me and I was able to try different angles of approach on both endgrain and spindle type cutting. I even used the little #3 for roughing inside and outside a small bowl blank. I was able to take heavy cuts all the while keeping the cutter angled to the wood. This setup is a little awkward to use, but for a quick fix it worked well. I just thought I would post this now to give others a helpful hint.

I think these Hunter tools would work really great on an NC type woodworking lathe, if they aren't already used by the industry.


img

Re: Training bar for a Hunter tool?

#2

Re: Training bar for a Hunter tool?

Juergen

>You should look at the Eliminator. The bar has machined flats which set the angle of attack for the cutter.

Re: Training bar for a Hunter tool?

#3

Re: Training bar for a Hunter tool?

john lucas

>That's very interesting but I think it's overkill. The hunter is very controllable. My suggestions to everyone is to start with the cutter at 45 degrees and move the handle left or right until you find the sweet spot to make it cut. you don't really find the sweet spot by rotating it flatter or steeper.

If you look at the cutter there is a bevel on the outside of about 7 degrees. This means if you stick the cutter in perpendicular to the wall or bottom of the vessel you will be cutting without the bevel rubbing. We know what happens when you do this, a catch, or at least an agressive feed. If you try to imagine the bottom of the cutter as the heel of bowl gouge it will help visualize what is happening. You set the tool on the wood so the heel is touching and then move the handle until the tip of the tool picks up the wood and starts cutting. This gives a lot of control over the cut.

Now go back to the 45 degree angle. The same thing applies to rubbing the bevel. You can rotate the tool flatter for a more aggressive cut or steeper for a cleaner slower cut but you still have to rub the bevel.

If you rotate the tool so it's flat, like a scraper, you can't rub the bevel because you can't lower the handle enough. That's why it want's to catch, or self feed at this angle.

Although I like your handle and can see advantages I think you give up the option of tilting the tool for different cuts. Then if you want to use it on the outside of a box or bowl you would have to change the angle of the handle again.

Keep thinking though. This is a new tool and people are going to come up with some novel ways to use it and I'm excited to see what people come up with.

Re: Training bar for a Hunter tool?

#4

That was my problem, John.

Eddie Pacheco; San Jose, Ca.

>I would be using the tool correctly and just for a fraction of time I would go of bevel and wham. This is helping me by just the shear weight of the bar.