Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Oneway Talon Question

Posts

Oneway Talon Question

#1

Oneway Talon Question

Bill Grumbine (Kutztown PA)

>Has anyone here had opportunity to take their Oneway Talon apart to clean it? I have one that has been getting sticky, balking as I turn it, and giving me trouble getting a good grip on tenons. I called Oneway and spoke with Kevin about cleaning it, and thought I was all set to go. As I disassembled it, I discovered two snap rings holding the scroll in where I thought there would only be one. I called Oneway again, at 4:33 PM, only to get the message machine which announced that they close at 4:30 PM on Fridays. I'm sure Kevin would be happy to answer my question, but I don't feel like waiting until Monday morning.

So, has anyone else discovered two snap rings in their chuck (manual says snap ring), or am I special? I am wondering if the second ring might be my problem.

Thanks.

Bill

Re: Oneway Talon Question

#2

Re: Oneway Talon Question

Carole Valentine

>Don't have a Talon, but from looking at the manual online, I would say you got a "bonus" ring. I would put just one back on and see if my problem was solved.

Re: Oneway Talon Question

#3

Re: Oneway Talon Question

Bill Grumbine (Kutztown PA)

>Hi Carole

I left the "extra" ring out when I reassembled it a little while ago, and it runs smoother than it ever did! Of course, I need to see how it runs on the lathe next. I haven't thrown that second ring away yet. ;-)

Bill

Re: Oneway Talon Question

#4

Re: Oneway Talon Question

Randy Privett

>Bill,

I would say that the snap ring groove was cut too large to begin with, so they added another snap ring to make sure it was tight. IMHO

Randy

Re: Oneway Talon Question

#5

I usually have left overs.

Stuart Johnson

>I seems like I always have some little screw, washer or bits left over when I finish reassembling something. I figure if I worked on my own truck for 10 years I would have enough odds and ends to build a new one.

One that worries me is a very large nut that ended up in the bottom of my table saw. There is nothing it will fit.

Re: Oneway Talon Question

#6

Re: Oneway Talon Question

Ed McDonnell

>Bill - I just checked my Talon and there is only one snap ring. Hope I didn't get shorted. Mine works very smooth.

Ed

Re: Oneway Talon Question

#7

Re: I usually have left overs.

Carole Valentine

>Stuart, that would worry me too! LOL I guess as long as it's not the nut that holds the blade on you don't have too much to worry about though.

Re: Oneway Talon Question

#8

Re: Oneway Talon Question

Frank J

>Hi Bill I opend my chuck up and there is only one ring.

Re: Oneway Talon Question

#9

Re: Oneway Talon Question

Bill Grumbine (Kutztown PA)

>Thanks for the responses everyone! Randy, I thought about the possibility of an oversized groove. It is a little looser than it was, but the parts aren't flopping around. I am going to leave the extra ring out for a while and see how it goes.

Bill