Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Pricing your work

Posts

Pricing your work

#1

Pricing your work

Keith Inscho E. Tenn.

>Hi folks,

I am sure this question has been asked lots of times but I'm kinda slow, so be gentle :) . I have mostly just given my turnings as gifts but I have been asked to place several for sale and I don't have a clue what to charge for them. Would someone please point me in the right direction? Thanks

Re: Pricing your work

#2

Re: Pricing your work

Barry Elder

>You should charge what you want to. Some will say it depends on the local market. Some will say you should figure cost of materials, depreciation of equipment, hours of labor at a certain rate, etc. Some will say it depends on the quality of the work and finish. But, in the end, what is it worth to you? You can never charge $200 for a bowl that you put a $30 price tag on.

Re: Pricing your work

#3

Re: Pricing your work

eliot d

>About all I can say about pricing has to do with pricing it for sale at a gallery or a shop. The price will then depend on the so-called "price point" of the shop or gallery. Of course, it's not actually a "point", but the place will have a certain range of prices for similar work, and you will just have to fit in, if you want to sell there.

Re: Pricing your work

#4

Re: Pricing your work

bowlman

>I know a couple big name turners that use a couple different formulae.

1: If its and open bowl or a hollow form, the price is $10.00/inch of max diameter (open bowl) or height (hollow form.

2: If you know the amount of time that went into the turning, charge $60.00/hour.

This all assumes your local market area can support such prices. And, these are retail prices. For wholesale, cut all prices in half.

Re: Pricing your work

#5

Re: Pricing your work

eliot d

>I would say that $10 for each inch of height for a hollow form is ridiculous! A squat hollow form, especially turned through a small opening, is an extremely difficult piece to turn and, all else being equal, should command a good price.

Re: Pricing your work

#6

Re: Pricing your work

Wally Dickerman in Arizona

>Actually, using formulas in pricing your work doesn't work. A slow turner shouldn't get a higher price for his work than a fast turner everything else being equal. Pricing by size doesn't work either. It's market value in whatever venue the piece is being sold. A high end gallery will ask a higher price than another gallery for the same piece. When selling in galleries the gallery manager should be consulted on prices. Pricing can be difficult.

Wally

Re: Pricing your work

#7

Re: Pricing your work

robo hippy

>Bowls under 6 inches, in the $10 range. 8 inches $20 to $40. 12 inch bowls, $60 to $100. 14 inches, $125 to $500. Turning time on a 9 inch wide by 3 inch deep bowl ready to sand, 10 years, and about 5 minutes. Prices vary according to market, wood, design, and if I like it or not.

robo hippy

Re: Pricing your work

#8

Re: Pricing your work

john lucas

>You also can't use a formula to price an especially desirable piece of wood. Take highly spalted maple vs plain maple. The spalted maple will sell for 4 times what the plain maple bowl will sell for. At least that's what I find around here.