Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Vicmarc 300

Posts

Vicmarc 300

#1

Vicmarc 300

gtw

>Finally got the lathe wired up today after moving, however when I turned on the VFD 2 little square red lights lit up and when I shut down the code LU came up.

Is there anyone out there in Vicmarc land that knows what this means?

Lathe runs both forward and reverse but the VFD makes a funny noise when I turn it off, don't want to run it in case of problems.

Any ideas gratefully received, Trevor

Re: Vicmarc 300

#2

Re: Vicmarc 300

Phil in NJ

>what brand of VFD and model # is it?

Re: Vicmarc 300

#3

Re: Vicmarc 300

gtw

>Phil,

It's a Fuji Model # FVR-E11s-7/7JE

Single phase 200 volt input, however I am reading 238 volts at the receptical, I have a 20amp breaker in the load center and a 30 amp breaker in the main panel in the house. Wired with #10 Tec and then #12 to the receptical.

The lathe has been dormant since January, perhaps just didn't notice the red lights before but this morning I noticed the green run light is on also. The red lights are the first and second on the key pad.

Thank you, Trevor