>ere is an ornament I just turned. It is an inside-out turned maple ornament with a carved cherry heart inside. The heart is captured by 2 mahagony finials and has a yellow heart arrow captured in the heart that can move and rotate. This was fun to make. The arrow tip is carved and lightly textured with a woodburner and the feathers were burned also.
>The arrow was flat, about 3/8 x 3/16 x 3" I chucked it up very carefully between my chuck and a live center. I turned the shaft with a smaller tenon in the center. I made sure that part A and part B were shorter than the width of the heart (part C) see the drawing. Then I parted it off so the tenon stayed with the half that went with the live center.
I used the point of a small skew to cut a center divot in the end of the arrow that was in the chuck. I chucked up the jacobs chuck and then center drilled the other part to the same size as the small tenon.
When it was all done I put some thin CA on the small tenon. inserted the parts in the heart and pushed them together. I've used this trick many times and it always fools people.