Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Bowl Turner's Bandsaw

Posts

Bowl Turner's Bandsaw

#1

Bowl Turner's Bandsaw

Bob Stroman

>Which bandsaw has wide and strong table support to the right of the blade? My bandsaw has only 7" of table to the right of the blade which only brings me to the middle of 14" blank after it has been cut round. Furthermore, most half logs cause the table to tilt when I wrestle them up there. Is there a bandsaw with a lot of table real estate to the right of the blade?

Re: Bowl Turner's Bandsaw

#2

build an overlay table?

Jeff Gerardot, Indianapolis IN

>Maybe you could build a table that clamps atop the CI table and extends to the right. Then put a leg on the extension to support the weight. (This table might be a good place to mount a circle jig, too...)

Re: Bowl Turner's Bandsaw

#3

Re: Bowl Turner's Bandsaw

JohnKJordan in East TN

>Bob,

While I would like a bigger heavy-duty bandsaw some day, I use a Delta 14" with a riser block. This will easily handle up to about 12" thick and bigger chunks than I like to muscle. I have no problem with the table tilting on this saw. Perhaps the trunion locking surfaces could be roughed up on your saw to minimize slipping. You might also devise a simple latch or bolt to prevent slipping. I also like the idea of a support leg - it could even be angled from the bottom edge of the table to somewhere lower on the saw frame.

JKJ

Re: Bowl Turner's Bandsaw

#4

Re: Bowl Turner's Bandsaw

Mike Cunningham (Cape May NJ)

>I'm unaware of any coming with the table you describe. However a suitable table is quite easy to construct, I did so on my 17" Grizzly and will post a photo later.

Mike

Re: Bowl Turner's Bandsaw

#5

Here you go Bob

Mike Cunningham (Cape May NJ)

>It's a simple table, made of 3/4" hardwood plywood, it's framed in solid stock which extends along the sides of the bandsaw table and through bolted to it with 4 bolts. It supports large blanks and can easily be removed. The only drawback, it has to be removed to change blades, but as I mentioned there's only 4 bolts and just takes minutes, besides I rarely swap blades, 90% of the time I have my bowl blank blade in use, the other 10% is the big resaw blade. I use Timberwolf blades from Suffolk and they last a long time..........

If you'd like additional photos, measurements, etc. email.

Hope this helps,

Mike


img

Re: Bowl Turner's Bandsaw

#6

Re: Here you go Bob

Bob Stroman

>Well done Mike! That's wide, stable, and simple too.