Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Using drill chuck in a lathe

Posts

Using drill chuck in a lathe

#1

Using drill chuck in a lathe

wilbur

>I was going to try drilling a hole in a blank by mounting a drill chuck on my lathe. Do you usually mount the drill chuck in the headstock and fix the block on the tailstock, or vice versa? I've seen methods where people have done both.

Also, does anyone have any action shots of a drawbar holding a drill chuck in a lathe? I think I know what I need to do for this, but it's nice to be sure.

Re: Using drill chuck in a lathe

#2

Re: Using drill chuck in a lathe

Tim GC

>Drill Chuck attached to MT2 in the Tailstock ... wood to be drilled attached to whatever you wish at the spinning end ...

Personally I do not like moving spinning things. Movement in 2 planes is courting disaster.

Just my �0.02

Re: Using drill chuck in a lathe

#3

Re: Using drill chuck in a lathe

Tony - Memphis

>That's what I do. One thing I had to learn was to tighten down the tail stock before moving the drill forward! I got my drill chuck at a machine supply place online. Works pretty well.

Tony

Re: Using drill chuck in a lathe

#4

Bit in the Tail Stock, Clear Often

Rick Urban

>Bit in the tailstock. If it's small (< 1/2) I just use it manually in a handle. My MT doesn't have a threaded hole for a draw bar, and that is a lot of setup time anyway for the number I would do at any one time. (The alternative would be to mount/remount blanks which would be as bad if not worse.) When I infrequently use my chuck I may give it a tap with a wood block to help set the MT in the tailstock to reduce slippage. Be sure to clear the cuttings / chips often or, depending on the type of bit, you will be in for a rough time when the heat causes the mess to expand and trap your bit.

Hope this helps.

Re: Using drill chuck in a lathe

#5

Re: I'm with you, Rick...

Allen Neighbors

>except I don't tap mine in with anything. I just use my hand on it to keep it from rotating. Doesn't take much... just sort of a mixture of hand holding and tailstock drilling.

For me it would be a mess trying to switch the piece to tailstock mounting, and using the drill chuck in the spindle MT.

I just keep my 1/2" bit in the chuck, right at the lathe. Makes it handy and fast.