Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Wish Bowls

Posts

Re: Wish Bowls

#26

Very nice!

Brian Hahn in SW Wisconsin

>I like that style of bowl and these look like they were a lot of fun to make.

Did you turn the little balls as well?

Re: Wish Bowls

#27

Re: Very nice!

Jennifer@Indy.USA

>Thanks Brian. The tiny spheres are not turned by me. I only burn the designs into them. I spent an entire day trying to turn the spheres that small and decided it was a lost cause. I'd have to charge $5000 for each Wish Bowl to compensate for the time it would take me to turn those! Ha! The spheres you see here are 3/8" diameter and I've been making some even smaller Wish Bowls that use 1/4" ones so you can imagine turning those.

Jen

Re: Wish Bowls

#28

On making a sphere.

Eddie Pacheco, San Jose, Ca.

>Not that I've done one yet, but on pg. 78 of Phil Iron's "Woodturning" book, he uses a hole cutter (hole saw) mounted in a handle to complete a sphere that he first created with a bedan. "The hole saw is used to remove any facets and complete the sphere, with the small burr on the inside doing the work. Don't let the sphere disappear into the hole cutter, as it could bind and whip the cutter out of your hand"

Looks a little scary in the picture, but I guess the process works well.

Re: Wish Bowls

#29

I tried that...

Brian Hahn in SW Wisconsin

>I tried the hole cutter trick when I was first making spheres this summer. I quickly gave it up. A spindle gouge and practice were a lot safer for me and the wood.

The only way I'd attempt spheres the size that Jen is using is to make them from the end of a dowel held in a chuck, using either a skew (shudder) or a very fine spindle gouge.

Re: Wish Bowls

#30

Re: On making a sphere.

Jennifer@Indy.USA

>Thanks Eddie,

I've heard of this process, but I don't think they make hole cutters this small :)

Jen