Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Nova chuck question?

Posts

Nova chuck question?

#1

Nova chuck question?

Barry Irby

>I bought a Nova chuck off EBay. Clearly a second. Very stiff. I thought it would loosen up with use, but it has gone the other way. Any suggestions what to look for if I take it apart and try to clean up what ever is binding it? Burrs, grit....what? Its the one that uses the big chuck key.

Re: Nova chuck question?

#2

Dick Hines

Re: Nova chuck question?

Dick Hines

>Barry, make sure the jaws are installed correctily. I took one of my Nova chucks apart to clean it and it did strange things until I got the jaws reinstalled right.

Re: Nova chuck question?

#3

is it warped?

JohnKJordan in East TN

>Barry,

It could be the chuck is binding from distortion caused by overtightening. There was a thread a few months ago discussing this.

I bought three additional chucks for my collection from a guy who evidently ate his Wheaties. (I like to have one chuck for each set of jaws to save time.) One was bound up like you mention - cleaning, lubricating, and working it didn't help a bit. It was so tight in places it was unusable.

I found by examination and careful measurement that the metal chuck body was distorted from the strongarming. One clue was the obvious out-of-flat condition of the top of the chuck body, as seen by reflected light, when the jaws were removed. Another clue was the pinion gear (internal in this one, on the key for yours) was badly worn from the abuse. Fortunately, that gear is softer steel than the circular rack gear inside the chuck so it was fine.

I repaired mine and today it works smoothly. I started by disassembling the chuck. I used a diamond sharpening stone to flatten the top, then carefully removed metal where needed on the chuck body with needle files and small diamond sharpening stones until I had the proper clearance and each piece slid easily.

JKJ

Re: Nova chuck question?

#4

Re: Nova chuck question?

Allen Neighbors

>Barry, it could be that it's just stiff from lack of lubricant. I bought a new Titan from Craft Supplies, and it was pretty stiff the day I received it. I took the back off of it, and there was just a dab of grease on the top of the worm gear - the bottom of the gears didn't even have a dab of the grease on them. I greased it with White Lithium Grease, and it now works better. It's still a little bit stiff, but at least now I know it's from being new, and not dry!

By the way... when you take the chuck apart to clean it, you do NOT have to remove the insert. DAMHIK!

Re: Nova chuck question?

#5

Dave Shombert

Re: Nova chuck question?

Dave Shombert

>Is it a SuperNova (I think that's what they call them) - keyed, chrome body? I got two of these for an obscenely low price at the Woodcraft basement sale a few years back. Like many things at the basement sale, I suspect they were returned purchases - in this case, because they were so stiff the key could barely move the jaws. It turned out to be because the snap ring that holds the pinion gear in place was not flat. I remove the snap rings (takes a pretty big snap ring pliers, I hadda get a new set at the auto parts store) and flattened them with a hammer on an anvil. Put it back together and they work great. Hope this helps.

Dave Shombert

Elkins, WV

Re: Nova chuck question?

#6

Dave Shombert

Correction

Dave Shombert

>Not the pinion gear, the ring gear. The big one. Sheeesssh.

Re: Nova chuck question?

#7

Re: Correction

Barry Irby

>Thanks. I've been eyeballing that snap ring. Thinking about going to an Auto parts store for a pair of players. Had not thought about the ring being warped or bent. Thanks again.

Re: Nova chuck question?

#8

Re: Correction

JohnKJordan in East TN

>>Thinking about going to an Auto parts store for a pair of players.

I have two snap ring tools and only one will remove that large a ring. I like the tools that come with a variety of replaceable tips. The last I got were Craftsman.

JKJ