Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Putting ends on rived & shaved spindles...

Posts

Putting ends on rived & shaved spindles...

#1

JL

Putting ends on rived & shaved spindles...

JL

>After riving and shaving my back spindles, I have another use for my lathe (other than the turned pieces). I chuck a 3/8" tenon bit into the Jacobs chuck and get a true 3/8" end. After I shave off the "fuzzies", I chuck a 1/2" tenon bit in the Jacobs chuck and do the other end to fit into my seats - this side is done to a "stop". That way I get a really close fit for the seat and the back rail. I then use my trusty spokeshaves to finish tapering the spindles to the desired shape.

I prefer shaving my back spindles as opposed to turning them. If the spindles are for a more "rustic" chair, I'll leave the tool marks on the spindles. Otherwise, I just shave them, use a chair devil to scrape them and gently sand them.


img

Re: Putting ends on rived & shaved spindles...

#2

Steven Antonucci

I don't understand?

steve antonucci

>Are you saying that you use the lathe like a shave horse or something else? Is that little black doohickey on the right one of those pencil sharpener things for sizing a tenon?

Can you explain it again? It's been a long day...

Thanks

Steve

Re: Putting ends on rived & shaved spindles...

#3

Yep

jay in tx

>Pencil Sharpener Doohickey = Black thing on right = tenon bit

Re: Putting ends on rived & shaved spindles...

#4

JL

Re: To clarify..

JL

>I use my shave "mule" as a shave horse.

After I rive my blanks, I rough shave them with a draw knife and my spoke shaves. This gets them to approximately the right dimensions. I then set them aside to dry for a month or so. If I'm in a hurry, I put them in a hot box to drive off the moisture and get them to 10-15% EMC.

After they have dried, I use a tenon cutter mounted in a Jacobs chuck to put a tenon on both ends. Not really a "pencil" sharpener, but a tenon cutter - though I suppose you could call it a "pencil sharpener" if you want :). This gives me a sized tenon for when I drill out the seat and the hoop that I'll be bending.

Re: Putting ends on rived & shaved spindles...

#5

Steven Antonucci

Thanks

steve antonucci

>Sure beats whittling them by hand, huh?

Steve