Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

OK now what (logs to lumber)

Posts

OK now what (logs to lumber)

#1

OK now what (logs to lumber)

Dave Bonde - Iowa

>My neighbor cut down a walnut tree and I managed to salvage a few chunks. But now what? I am mainly asking about how to process the two crotch pieces in the picture. One is small and the other is large. I have a chainsaw and a MM16 bandsaw but have not processed logs into material to turn on the lathe just flat stuff. Any suggestions on how to proceed would be appreciated. Dave


img

Re: OK now what (logs to lumber)

#2

Re: OK now what (logs to lumber) *LINK*

Philip Morris

>Dave,

Bill Grumbine's website has a good pictorial essay entitled "Sawing a Log for Bowl Blanks". The link below will take you to his homepage. The article is under the "For Turners" section.

Philip


http://www.wonderfulwood.com/

Re: OK now what (logs to lumber)

#3

Steven Antonucci

Depends on what floats your boat

steve antonucci

>If I was going to make a bowl, I section it in half through both piths and make the inside of the log the bottom of the bowl. Or you could align the center of the crotch with the centerline of an end grain hollow form.

Up to you.

Steve

Re: OK now what (logs to lumber)

#4

Thanks for the info

Dave Bonde - Iowa

>