Portland Woodworking Show
Jerry Klug
>The Portland Woodworker Show had fewer exhibitors than any show I have attended. I have been going to the WWSs for many years and this was so poorly done I won�t attend another until I hear that they have great improvement. There was little promotion. I got a postcard in the mail three days before the show. I wouldn�t have any other advance notice if I hadn�t been regularly checking their web site. Since it is a 150 mile drive, I had hoped to make it worthwhile. I had hope of getting a number of turning supplies but there were no turning vendors at the show, not Packard, Craft Supply, Rockler or Woodcraft. I was able to get most of what I needed by visiting the Beaverton Rockler store and the Tigard Woodcraft. Woodcrafters had a big display of only Festool equipment. The spring Puyallup, WA show was smaller than I remembered previous shows but there was a lot for turners to see and learn from with the Craft Supply classes. This one was quite a disappointment for every turner I spoke to.
The one bright side was that I was able to order a Powermatic 3520B through Western Tool at a price below any on the internet. It will be delivered to the Bend Western Tool store in about 2 weeks. Now I have to figure how to safely unload it. The 3520B was the only lathe on display at the show other than a few minis. I got a 5 piece turners set of Crown tools from Rockler at 20% off for their Show Special e-mail coupon and a SuperNova2 chuck from Woodcraft for $149. When the lathe arrives I will be ready to start making some shavings. After I get some proficiency at smooth cutting, I can start looking at expanding my tool inventory.
The only small things I got at the show were some accessories for my Tormek, a splitter for the table saw (that Peachtree only sells at shows), some chip collector fittings and a nifty spring actuated center punch. They are available at Woodcraft but were discounted at the show. If it weren�t for the lathe, it wouldn�t have been worth the parking fee let alone the admission.
Next weekend is the Consumer Woodworking Expo In Seattle. I would like to hear how this new show is organized.
Now I have to get busy and get the shop ready for the �mustard monster�.



