John Lucas's Hunter #1 tool
Dennis Yoder
>John, What kind of steel did you make your #1 Hunter tool that you had at IndyFest? Dennis Y
Knowledge You Can Build On — Est. 1998
John Lucas's Hunter #1 tool
Dennis Yoder
>John, What kind of steel did you make your #1 Hunter tool that you had at IndyFest? Dennis Y
Re: John Lucas's Hunter #1 tool
john lucas
>Dennis I made the shafts of the round ones with common cold roll steel. The flat one was also cold roll. It's easier to work and you don't need high carbon steel just to hold the carbide cutter.
Cold Rolled is at HD and Lowes
steve antonucci
>And it's also less expensive than the "pretty stuff". I made a few with each, and John's right, you don't need the "good stuff" to hold a cutter.
steve
Re: Cold Rolled is at HD and Lowes
Dennis Yoder
>cold rolled it is. Thanks Dennis Y