Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Budget hook tool *LINK*

Posts

Budget hook tool *LINK*

#1

Budget hook tool *LINK*

Robert D. Macgregor

>I read the thread on hook tools with interest. Have any of you made the hook tool described at http://www.aroundthewoods.com/hooktool.shtml ? There is also a link on that site to video of the tool in use. I know this involves masonry nails, not tool steel, but access to cheap materials means they can be mass-produced in the shop to make up for any breakage... of course, they're still not carbide, so they'll get dull faster.


http://www.aroundthewoods.com/hooktool.shtml

Re: Budget hook tool *LINK*

#2

Re: Budget hook tool

john lucas

>Robert I have used masonry nails in my tool making demoes. They do work but I prefer my hook tools to be a little beefier. For just a few dollars you can buy a 36" piece of drill rod from use-enco.com and you get a thicker metal and you know what medium to quench in. In fact you can order the hardening instructions enco at no charge. It tells you exactly what temperature to harden and what temperature to anneal for what Rockwell hardness. That lets you have fun by trying different hardnesses for different tools.

Re: Budget hook tool *LINK*

#3

Another source

Roger Smith

>of tool steel is Fastenal. Most average to large towns have a local store. They also stock 1 inch and 1.25 inches by 8TPI nuts.

Re: Budget hook tool *LINK*

#4

Re: Budget hook tool

Allen Neighbors

>I had a go at it. I had some masonry nails so I made a couple, following Darrell's instructions. I did use them, and learned how not to use the, too. I broke both of mine, and never tried to make anymore... seemed like a lot of work for too little results. I know I just didn't do it right, because I've heard of too many people using them and loving the way they cut. I may have to try John's suggestion, and make some out of drill rod.

However, I bought the Small Hunter hollowing tool from Mike at SWAT. The cutter is mounted on a 1/4" round shank. I put it in my 1/2" Oland shaft. It is my reach for tool now, when I am cutting endgrain. So far, I've hollowed four little boxes with it, and have been starting with 180 or 220 grit paper. I could never do that with a bowl gouge or Oland tool.