Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Rockwell 46-111 Wood Lathe

Posts

Rockwell 46-111 Wood Lathe

#1

Rockwell 46-111 Wood Lathe

George@Colonel's Workshop-Havertown PA

>Good Afternoon Friends,

My best friend has purchased an old Rockwell lathe which appears in flawless shape. I have turned a bowl on it, and its smooth and powerful. 4 speed dual stepped pulley system with the Rockwell Motor slung below the stand. I noticed the motor speed was 3400 rpm or so as compared to the 1725 on my Jet 1236 lathe. We have no way of knowing the spindle speeds at various pulley settings. It seems to spin pretty fast as compared to my Jet. Is the 3400+rpm motor on the Rockwell normal for that tool? Can anyone furnish the actual spindle rpm at the four pulley settings? I've looked for useful info from the Delta web site, but got only an exploded parts diagram. One other question. It needs a replacement drive spur. Is a #2 Morse correct? Thanks,

George

Re: Rockwell 46-111 Wood Lathe

#2

Re: Rockwell 46-111 Wood Lathe *LINK*

Mike Cunningham (Cape May NJ)

>HI George

I recently sold the same model lathe to someone. It was a 1971 Tupelo built model and had a Rockwell/Delta 3400 rpm motor with 4 step pulley on the motor and headstock.

OWWM had a great calculator but they seem to be offline. Try the link for an alternative.

Mike


Pulley RPM calculator

Re: Rockwell 46-111 Wood Lathe

#3

Re: Rockwell 46-111 Wood Lathe

George@Colonel's Workshop-Havertown PA

>Thanks Mike,

I'll get the pulley diameters and plug in to the formulaes. I wondered about the twin pulleys as being the original configuration, and the rpm as being the original motor speed. I really like the tool. Did you ever develop a bolt on devise which could be used to easily swing the motor/detension the belt for switching the speeds/pulley steps?

George

Re: Rockwell 46-111 Wood Lathe

#4

Re: Rockwell 46-111 Wood Lathe

Mike Cunningham (Cape May NJ)

>The original was a movable bracket. Mine was mounted on a board with a hinge at the rear and the motor could be lifted to release the belt. I had a short lever beneath the board to liftby stepping on with my foot. If you need V belts, a good source is McMaster Carr.

There's also an aftermarket Rockwell/Delta supplier and I can find that source if you have a need.

Mike

Re: Rockwell 46-111 Wood Lathe

#5

Re: Remember that this is basically..

Jamie Donaldson

>... a spindle lathe by design, and they spin faster than a bowl lathe should.

Re: Rockwell 46-111 Wood Lathe

#6

Re: Remember that this is basically..

Mike Cunningham (Cape May NJ)

>Yeah, the minimum is probably around 450 - 500 rpm.

Re: Rockwell 46-111 Wood Lathe

#7

Re: Rockwell 46-111 Wood Lathe *LINK*

Mike Cunningham (Cape May NJ)

>George,

Here's the other arbor speed calculator that I mentioned, OWWM must have down earlier.

Mike


OWWM