Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

When you are stupid you are suppose to suffer.

Posts

When you are stupid you are suppose to suffer.

#1

Dick Hines

When you are stupid you are suppose to suffer.

Dick Hines

>I had the day and after some yard work I started to turn some bottle stoppers for a gallery tour this weekend. Every thing was going great until key chuck decided to unseat from the headstock. I had just finished sanding the stopper and put a friction wax on. Not wanting to start over with the sanding if the chuck dislodged I hit with my hand. STUPID!!!!. I now have three fingers that are ground down.

The next time the key chuck wants to run off some were I will just let it go.

Re: When you are stupid you are suppose to suffer.

#2

Keith Tompkins

Re: When you are stupid you are suppose to suffer.

keith tompkins

>Bummer, Dick. Many chucks are threaded for a draw-bolt. If your lathe has a hollow spindle, it solves that problem.

Re: When you are stupid you are suppose to suffer.

#3

Mike Stafford

Re: When you are stupid you are suppose to suffer.

Mike Stafford

>Dick, that sounds painful. Let it go, let it go. Get out of the way but let it go.

Re: When you are stupid you are suppose to suffer.

#4

Re: When you are stupid you are suppose to suffer.

Carole Valentine

>Dang, Dick. How bad are your fingers? Did you have to go to the ER?

Re: When you are stupid you are suppose to suffer.

#5

Dick Hines

Re: When you are stupid you are suppose to suffer.

Dick Hines

>No ER for. Just some paper towel pieces and masking tape.

Re: When you are stupid you are suppose to suffer.

#6

Re: When you are stupid you are suppose to suffer.

eliot d

>Try to get hold of the September 2005 issue of Woodcraft magazine. On page 37 there's a five page article (Project 18) called "Shop-Made Collet helps you GET A GRIP". It's an extremely easy turning project designed to make a chuck specifically for turning bottle stoppers; and, of course, it can be used for other small stuff. There's no way you could get hurt using one of these.

Re: When you are stupid you are suppose to suffer.

#7

Dick Hines

Re: When you are stupid you are suppose to suffer.

Dick Hines

>Bet I could.

Re: When you are stupid you are suppose to suffer.

#8

Re: When you are stupid you are suppose to suffer.

eliot d

>Well, it's a wooden chuck, so it's at least less likely. Glad you weren't hurt bad.

Re: When you are stupid you are suppose to suffer.

#9

Re: When you are stupid you are suppose to suffer.

Rick Urban

>Glad you weren't seriously hurt. I salute your courage in letting us know, too. (I have too many red badges of courage ane too much cowardice to share here.) That's why I, too, get nervous about JT33 tapers and 2MT tapers being the only things that hold the stuff to the spindle. It all led me to doing bottle stoppers with a 3/8" 2MT collet which I am quite comfortable with.

Re: When you are stupid you are suppose to suffer.

#10

Dick Hines

Re: When you are stupid you are suppose to suffer.

Dick Hines

>Rick, I learned to turn by the blood letting method. This is not the first time I have lost shin, meat and blood to the lathe gods. I was lucky I did not do more damage. I got back on the horse this afternoon. I turned some more bottle stoppers.