Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

kelton set screws

Posts

kelton set screws

#1

kelton set screws

keith zimmerman, Normal IL

>I've lost a couple of the set screws for my kelton handle and need to replace them. Does anyone know where I can get replacements?

Thanks

keithz

Re: kelton set screws

#2

Re: kelton set screws

Leppikallio

>I think (if I remember correctly) those were metric set screws, either 5mm or 6mm? Does 1/4" screw fit almost? If it does then it probably is 6mm thread...

If you can't find metric set screws closer I can send a letter to you. On this side of pond those are easy to get and cheap also.

Re: kelton set screws

#3

Re: kelton set screws

Jorge Castaneda

>Keith,

I got replacements for mine at the local hardware store,

I just took in the handle and then tried screws until finding the righ one.

Re: kelton set screws

#4

Re: kelton set screws

George Van

>Like Jorge, I got mine at Ace Hardware.

Re: kelton set screws

#5

Re: kelton set screws

john lucas

>me too. My local ace hardware has a good selection of set screws in both metric and english sizes

Re: kelton set screws

#6

Dick Hines

Re: kelton set screws

Dick Hines

>Check a good hardware store but don't try Lowe's or HD. Been there done that.They no got.

Re: kelton set screws

#7

Re: Did you try the specialty hardware drawers?

Al Crandall

>I have had good luck finding what I needed at Lowe's in the drawers of specialty hardware. Two days ago I bought two 1/2x3" socket head cap screws from those drawers. I'm positive that I have bought metric screws from the metric drawers also, but I can't remember definate sizes. I know that the metric screws holding the shopmade chuck jaws on one of my Talon chucks came from the drawers at Lowe's. I don't shop HD.

Re: kelton set screws

#8

Re: kelton set screws

Gordon Seto

>It is 8mm diameter x 8mm long. They are so easy to get lost on the unused end;; I bought several spares.

Gordon

Re: kelton set screws

#9

Re: kelton set screws

Gordon Seto

>You can find this metric "Set Screw - Socket" at the HD and Lowes. I have purchased from both.

Gordon

Re: kelton set screws

#10

Thanks everyone,

keith zimmerman, Normal, IL

>I'll stop tonight. I have all the sources mentioned available to me. I thought they would be readily available, but have never purchased any before.

keith

Re: kelton set screws

#11

Dick Hines

Re: kelton set screws

Dick Hines

>I have started putting a piece of tape over the unused end to keep the screws out of the chip pile.

Re: kelton set screws

#12

Re: kelton set screws

Stuart Johnson

>Duh, this is a forehead slapper. You might want to send this simple but time saving tip to John.