Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

American Woodturner tips needed

Posts

American Woodturner tips needed

#1

American Woodturner tips needed

john lucas

>I have just sent off the latest tips to the American Woodturner and I'm getting low so I need some more tips for the next issue. If you have something you do in your shop that you think others might find useful please send it too me and I'll see if we can use it. They pay $35 so be sure and send me your address along with the tip. Any photos should be as large as you can mail them. I can shrink them down if needed.

Re: American Woodturner tips needed

#2

Re: American Woodturner tips needed

Bill Hale / The Wood Spinner

>John

How about a cheap guantry for lifting larger pieces of wood to the lathe.

I used Barn track on a frame as mine is under the garage door. I would sugest installing two tracks one on the front and the other on the back side of the lathe. Then make a cross bar attached with the track wheels. I used a 4 x 6 with a ring bolt in the center over the lathe. I then attached a small one ton chain fall to the ring. Use a ratchet tie down strap on the wood, attach to the hoist and roll up the piece. Move the cross arm as need for mounting and adjust height with the falls.

If you have the ceiling height a third piece of track can be mounted to the cross arm and the falls mounted to that for full 3 direction lifting and motion.

I do some larger stuff and I can turn larger than I can lift.

With a little scrounging this can be built under $ 100.00

Bill Hale

POB 1026

Casa Grande, AZ.

If you decide to use this just keep the money as a membership donation

Re: American Woodturner tips needed

#3

Re: American Woodturner tips needed

john lucas

>Thanks I sent the tip to my work e-mail which is where I deal with the tips.

Re: American Woodturner tips needed

#4

Re: American Woodturner tips needed

eliot d

>It's often difficult to remove the nib that usually appears at the bottom of a closed hollow form. A technique that I use is to reverse the direction of lathe rotation and move the cutting tip of a swan neck tool from right to left through the nib.

Eliot Feldman

9311 Friars Road

Bethesda, Maryland 20817

Re: American Woodturner tips needed

#5

Steven Antonucci

Similarly...

steve antonucci

>I have an Ellsworth style bar with the cutter set at 45 degrees. My lathe does not reverse. With the lathe running normally, I reverse the cutter in the bar!

Since I use a set screw to secure it, it takes two seconds to unscrew, flip, and retighten. When I'm done, it's back to business as usual.

You can keep my $35, John :-)

Steve

Re: American Woodturner tips needed

#6

Re: Similarly...

eliot d

>I would have to say that I think your solution is more elegant in that a big issue with many turners is that they don't have a lathe that reverses direction.