Re: Jacobs chuck *LINK*
Clem Wixted, Jonesboro, AR
>Lou,
You are about half way there.
The Jacobs chuck needs to be fixed into the headstock (or tailstock) with a #2 Morse taper, You have a #2 Morse taper female in your headstosk spindle and tailstock spindle.
The chuck needs to be connected to the #2 Morse taper.
The connection is a male arbor that has a #2 Morse taper on one end and a "connection mechanism" on the other end. The "connection mechanism" has to match the inside of the Jacobs chuck.
Most of the simple Jacobs chucks I've seen at a hardware store have a threaded hole inside of the chuck, or a hole that a screw goes through to connect it to a tool, such as a drill.
You will probably need something a little stronger than a screw to hold the chuck to an arbor.
Many of the lathe chucks have a "socket" that the #2 Morse taper arbor mates to for a solid and strong connection, rather than a screw or threaded hole.
Below is a link to more information about Morse tapers than you may care to know :-)
HTH,
Clem
Morse Taper Information