Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Celtic Knot Spheres

Posts

Celtic Knot Spheres

#1

Celtic Knot Spheres

Brian Hahn in SW Wisconsin

>I was sidetracked by geometric patterns for a while. The front ball is cherry, 2-3/4" diameter, Deft spray and black gesso. The left ball is aspen, 3-1/4" diameter, acrylic paints and Deft spray. The right ball is elm, 3-1/4" diameter, acrylic paints and Krylon matt finish.

The stands are turned from polyester casting resin.

Comments welcome.


img

Re: Celtic Knot Spheres

#2

JL

Re: Celtic Knot Spheres

JL

>I pretty much like them all. However, the one on the back left seems a bit "garish" in comparison to the other two.

Re: Celtic Knot Spheres

#3

Re: Celtic Knot Spheres

Brian Hahn in SW Wisconsin

>I agree about the left one. People were having trouble seeing the Celtic knot in the right one, so I made the left one to make the knot really obvious. I found the result to be "over-stated" (i.e. garish).

Re: Celtic Knot Spheres

#4

Re: Celtic Knot Spheres

Norm Smith

>Hey Brian, I like them all. Well done.

Norm

Re: Celtic Knot Spheres

#5

Re: Celtic Knot Spheres

George Van

>Well done Brian, the one in the front really grabs my eye!

Re: Celtic Knot Spheres

#6

Re: Celtic Knot Spheres

Peter Hyde

>Brian, are these knots? I notice that you don't have the bands going over and under in a consistent manner, which as I understand, is what makes a knot.

Just my .02

Re: Celtic Knot Spheres

#7

Well...

Brian Hahn in SW Wisconsin

>These are a Celtic Knot to the same extent that a Celtic Knot pen or goblet is. The painting on the left sphere is definitely a Celtic Knot. The descending lines are on top of the rising lines, but just to confuse matters, there are two layers of knots. The wider primary color lines (red, yellow and blue) are the outer layer and are on top of the narrower secondary color lines (orange, green and purple).

Re: Celtic Knot Spheres

#8

p.s.

Brian Hahn in SW Wisconsin

>The knots in the left sphere are more obvious when you can hold and rotate the sphere. But they aren't very obvious at all in the photograph, especially with the lighting and the angle I used. And having two layers of knots only adds to the confusion.

I have two other simple geometric patterns that can't be captured in a single picture - they have to be seen in all three dimensions to be understood.

Re: Celtic Knot Spheres

#9

Re: Celtic Knot Spheres

Molly Winton

>These are wonderful Brian! Your lines are crisp and clear, with excellent color application. Beautifully done! I bet they're wonderful to hold.

Re: Celtic Knot Spheres

#10

Re: Celtic Knot Spheres

Brian Hahn in SW Wisconsin

>Thank you Molly. They are fun to hold and examine in your hand. Also, the bowl is just the right size that when you remove a ball the remaining balls move around for a while. The same thing happens when you put the ball back. Sort of a dynamic sculpture. I took the bowl and balls to the Badger Woodturners meeting this week and several people really enjoyed playing with them.

Re: Celtic Knot Spheres

#11

Re: I'm with Molly on how......

Jamie Donaldson

>...in the world did you apply the colors so uniformly and without runs??? Well done!!!!

Re: Celtic Knot Spheres

#12

The painting isn't that difficult.

Brian Hahn in SW Wisconsin

>It just takes time, patience and top quality materials.

1. Seal the wood to prevent bleeding. I used 2-3 coats of a 1# cut of blonde de-wax shellac.

2. Apply a medium viscosity artist acrylic with a quality water color brush. I used Liquitex Soft Body (formerly Medium Viscosity) acrylics. Golden Fluid acrylics are equivalent. The water color brushes were a sable/synthetic blend, but next time I'll spring for pure sable brushes ($$$). The colors go on smooth and the water color brushes are soft enough that brush marks are minimal.

3. Hand-sand the turning to remove the over-painting and then hand-sand through the grits.

4. Seal with another thin coat of de-waxed shellac, then top-coat with the final finish.

For the solid bands, I only painted the outer grooves before sanding, then went back and filled in the bands.

The black gesso on cherry was a little more challenging. I didn't like the shiny surface from the lacquer, so I sanded the bands clean and reapplied the gesso.

Re: Celtic Knot Spheres

#13

That one is my favorite as well.

Brian Hahn in SW Wisconsin

>

Re: Celtic Knot Spheres

#14

Re: The painting isn't that difficult.

john lucas

>Jamie Back in my Archery days I used to paint arrows. I spun the arrows in a homemade lathe sort of jig. I found the quality of the paint and the brush made more difference than anything. A good quality lacquer thinned enough to not glob applied with a good quality brush, would leave a really clean line, thick or thin. With wood of course you have to seal it well enough so the paint doesn't soak in.

Re: Celtic Knot Spheres

#15

Re: John- it is more amazing to .....

Jamie Donaldson

>...me every time we talk how similar our pathes thru life have been! I was also a very serious archer in my earlier years, including making my own bows and arrows, and the electric arrow spinner morphed into a fishing rod spinner that I still have. I just haven't had much time to use these toys in recent years, but maybe some day!

Re: Celtic Knot Spheres

#16

Re: John- it is more amazing to .....

Jamie Donaldson

>...me every time we talk how similar our pathes thru life have been! I was also a very serious archer in my earlier years, including making my own bows and arrows, and the electric arrow spinner morphed into a fishing rod spinner that I still have. I just haven't had much time to use these toys in recent years, but maybe some day!

Re: Celtic Knot Spheres

#17

What can I say, great minds think alike.

john lucas

>