Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Chuck won't thread spindle

Posts

Chuck won't thread spindle

#1

Chuck won't thread spindle

Travis Northcutt

>Hey folks, I need some help. I have a Jet Mini 10X14 and I use a nova midi chuck. I moved my lathe to the house a couple months ago. Apparently during the move I did something to the spindle and now my chuck won't thread on. I noticed it the first time a couple weeks ago when I went to turn a bowl. I filed the threads some, but it still won't thread. It turns about 2-3 threads and then sticks.

If anyone has any suggestions or if this has happened to you, I am open to advice. Thanks.

Re: Chuck won't thread spindle

#2

Re: Chuck won't thread spindle

Carole Valentine

>Are you sure it's the spindle threads? Have you checked the threads of the chuck for any tiny piece of trash or metal filing? Can you by any chance borrow a friend's chuck and see if it has the same problem? If it does it's the spindle threads and if it doesn't, it's your chuck threads.

Can you actually see any damage to the spindle threads?

Re: Chuck won't thread spindle

#3

Re: Chuck won't thread spindle

Travis Northcutt

>I'm sorry. I forgot to mention that I screwed the chuck onto another lathe and it worked fine. Sorry about that.

Re: Chuck won't thread spindle

#4

Re: Chuck won't thread spindle

don lewonczyk

>If the threads look okey on the spindle and you already know the chuck is okey try putting a straight edge along side the spindle and rotate the spindle by hand very slowly to see if you didn't put a bend in it while you were moving it. It wouldn't take a big bend to bind your chuck acouple of threads into it. Hope it helps easy enough to at least try it. Don L

Re: Chuck won't thread spindle

#5

Re: Chuck won't thread spindle

don lewonczyk

>Also put your drive center in and see if it still lines up with your live center in the tail stock, that would really show any problems with the spindle being bent. Don L

Re: Chuck won't thread spindle

#6

Re: Chuck won't thread spindle

john lucas

>travis If you still have one of the faceplates try that. I've had problems with chucks and other brands of faceplates not fitting on all my lathes. Usually filing the tops or insides of the threads has done the job for me. I would think you could see the damage if the chuck used to fit but doesn't now.

Re: Chuck won't thread spindle

#7

Re: Chuck won't thread spindle

tek-Brunswick, Ohio

>Does your chuck have a set screw, that keeps it from unscrewing if the lathe is in reverse? Maybe it is partially extended. Far enough to bind on your lathe, but not far enough to bind on the other lathe.

Re: Chuck won't thread spindle

#8

Re: Chuck won't thread spindle

John Veerkamp

>I assume that your lathe has 1X8 threads. Go to your local hardware store and buy a 1X8 nut and run it all the way on and off the spindle several times. It will clean up those damaged threads. BTW you may need to use a little muscle the first pass.

Beats paying $25 for a die.

John

Re: Chuck won't thread spindle

#9

Well, what did you find out?

RPE

>