Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Hole diameter in Jamieson standard boring bar?

Posts

Hole diameter in Jamieson standard boring bar?

#1

Hole diameter in Jamieson standard boring bar?

Craig Daymon

>What is the diameter of the hole (or of the swivel tip holder post) in the Jamieson standard boring bar? I'm planning on making a boring bar myself (or possibly 2) and want to know the size to be compatible with the swivel tip cutter post. I know the cutter is 3/16".

Or is this even important? For those with the swivel tip holder, how often do you alter the swivel position? Maybe I should just drill a 3/16" hole in a 3/4" bar at 45 degrees, add a set screw to hold a cutter and call it done? I think that would also work if I wanted to use the Hunter tip?

-Craig

Re: Hole diameter in Jamieson standard boring bar?

#2

Re: Hole diameter in Jamieson standard boring bar?

john lucas

>I don't know about the Jamieson bar but I drill 1/4" holes and insert the 3/16" cutter in those. Sometimes you have to just barely knock the corners off. I think it depends on how accurate the 1/4" hole is.

Re: Hole diameter in Jamieson standard boring bar?

#3

Re: Hole diameter in Jamieson standard boring bar?

Don Evans

>Craig, the post is 3/8"

Don

Re: Hole diameter in Jamieson standard boring bar?

#4

Re: John, I think it's 17/64s bit that ...

Allen Neighbors

>you use to drill the hole, so you don't have to knock the corners off the 3/16 square cutter. If it's not that one, it's 9/32.

Re: Hole diameter in Jamieson standard boring bar?

#5

Re: John, I think it's 17/64s bit that ...

john lucas

>Allen Actually a 1/4" hole is so close you can usually push the 3/16 cutter into the hole with a little force. I just hit the corners with a file with maybe one or two strokes. this lets it go into the hole easily. If I am gluing the cutter into the hole I don't do that I simply push it in and add CA. I knock the corners off a little when using the setscrew so it's easier to remove the cutter.

I may try 17/64's on a test piece to see if that's better but I don't want a sloppy fit.

Re: Hole diameter in Jamieson standard boring bar?

#6

Re: Give me a couple of weeks...

Allen Neighbors

>and I'll be able to answer you. I'm planning on picking up a couple of Hunter tips at SWAT. Just depends on if I can conform my current handles to use his tool tips. I have too many handles, and don't want to have to deal with more right now. (that's not a stealth gloat, either... it just proves that I'm easily swayed.)

Re: Hole diameter in Jamieson standard boring bar?

#7

Re: On my larger tool bars

Allen Neighbors

>I use two set screws, so I don't mind if the hole is slightly oversized. I can get the cutter out quicker and easier to slip in one that's been sharpened. Before I used the larger bit, I sometimes had to get the pliers to pull the cutter out. Do you ever have that problem... even after knocking the corners down a mite?

After thinking about it and visualizing my bit box, I believe it is the 9/32 that I use for a 3/16 cutter... because it's the second bit above the 1/4.