Hand Model
tek-Brunswick, Ohio
>Here is one of our members working on the Demo lathe. He is making an icicle for a Christmas Ornament.
Knowledge You Can Build On — Est. 1998
Hand Model
tek-Brunswick, Ohio
>Here is one of our members working on the Demo lathe. He is making an icicle for a Christmas Ornament.
Re: Hand Model
Gordon Seto
>Whoever doing the demo should be proud to have his face shown. I assume he is demoing on the Jet mini lathe. By proportion, that is a long and slim icicle.
Congratulations on a good show.
Gordon
Re: Hand Model
Bill Noce in Northeast Ohio
>Like the picture of my hands Tom......I just finished spraying the completed ornament today.....I post a picture of it tomorrow if I get a chance....
Bill
Re: Hand Model
tek-Brunswick, Ohio
>I'm going to finish the one I started also, but I'm not as far along as you are. Thanks again for helping at the show.
Tom
For Gordon
tek-Brunswick, Ohio
>Here is a full frontal view of our hand model. He must have reflective tape on his sleeves. I think he was hollowing a miniature here.