Re: "fire-safe" Alternate options
Mark Mandell - Gone Round In Jersey
>Hi Brodie,
Thanks for the thoughts. I'm not in a position to enclose the DC as too much other stuff runs right by it, but it is located in a corner so that a heat spike is likely to be more localized over the collector bags where the sprinkler would be located. As far as the going away situation, its been my sop for years to empty the DC bag and kill the breakers for both the shop and the compressor before leaving for more than a day trip. Heck, I even unplug the toaster, the coffee pot, and the cell phone chargers! |;-}
The Halon systems are only used around here for computer and electronics areas because of the cost of both the set-up and the chem. I'm not worried about a bit of water in the garage, it runs out under the door, and there's nothing in there that a good shower's going to hurt.
Had a guy over the other day and he recommended a 135* sprinkler head so that the entire garage wouldn't have to get so hot (155 is the next up) for the system to activate. Of course he also tried to sell me on a sophisticated supression system made just for garages. The house and the garage are hardwired for smoke, so I'm not too worried about a 2am garage fire catching us asleep; we'd have lots of time to get out with the cats. The danger would be the wood dust catching and then spreading to the vehicles and other gas tanks parked in there. That could take the house before the trucks arrived. No flamables are stored within 15' of the DC, and the sheetrock is all fire-stop rated, so I think the water head and an audible external alarm will be enough.
Thanks again for the suggestions!
mm