Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

face plate

Posts

face plate

#1

face plate

Paul Waddle

>Anyone got an extra faceplate they don't need? I want either a shopsmith type that fits to shaft with set screws or one that I can bore out to use set screws. I should think any small one,say 3-4" would work. I'd like to bore out to 1" or larger and have enough diameter on shank to use set screws. Thanks,Paul W

Re: face plate

#2

Re: face plate

john lucas

>Are you going to use it on a 5/8" shaft like the shopsmith or 1". I don't think the shopsmith faceplates have enough metal to bore out to 1"

Re: face plate

#3

Re: face plate

Ron in Drums PA

>Face plates are like clamps, you can never have to many.

Shopsmith you say? Isn't that a 3/4" x 16tpi? IIRC, you can buy a fixture in the plumbing dept that would work.

Re: face plate

#4

Re: face plate

Don in Central Illinois

>Shopsmith doesn't use threaded faceplates. They 'slip on' the headstock and are fastened with allen screws.

Re: face plate

#5

Re: face plate

Paul Waddle

>Thanks Ron,Don and John-they rhyme. ha ha. Yep,I know the shop smith uses a slip on faceplate held on by set screws-I was just using it an analogy to discribe what I think I mean. You're probably right John,I'm not sure how thick the shank is. Now to explain a little futher,I could use a 1-8 threaded plate as the top of the threads are less than 1",the root diameter is ~1". I believe boring to less than an inch ,will give me a good purchase(or should I say bite before this is misconstrued) ha ha No, I don't want to bite or purchase-thanks for the replys.pw ps Wife says I have too much time on my hands.

Re: face plate

#7

Re: face plate *LINK*

Ron in Drums PA

>Sorry about the misinformation


Ebay - Shopsmith Faceplates

Re: face plate

#8

Steve Kubien

I think I've got one

Steve Kubien

>Hi John,

I think I've got a 5/8" plain x 3" diameter Don Pencil aluminum faceplate in the shop. It's designed for a Shopsmith. It's yours for postage if you want it. Send me an email.

Steve Kubien

Ajax, Ontario

Re: face plate

#9

Re: I think I've got one

Paul Waddle

>Thanks Steve,email sent,pw