Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Electric motor experts?

Posts

Electric motor experts?

#1

Electric motor experts?

Jim Miles-Charlotte, NC

>I have a 1/2 Horsepower, AC electric motor, 1750 rpm. when it is turned on it hums and does not start or starts up slowly, if I turn it be hand to start it then it goes. What might the problem be? Thanks in advance!

Re: Electric motor experts?

#2

Probably the start capacitor

Gil Jones on Lake Seminole GA

>

Re: Electric motor experts?

#3

Re: Electric motor experts?

Jim Terry

>Jim,

Sounds like you may have a bad starting capacitor. Check and see if you have one mounted on the side of the motor. The capacitor provides enough phase shift to start to rotor turning.

Jim Terry

Re: Electric motor experts?

#4

Re: Probably the start capacitor

Ken Oakley-Sunny St. Cloud, Fla.

>My guess also

Re: Electric motor experts?

#5

Or it might be the centrifugal switch

Brian Hahn in SW Wisconsin

>I had a similar problem with the motor on my old Craftsman table saw. Enough dust had built up inside the motor that the centrifugal switch that controls the starting capacitor no longer worked. I cleaned out all of the dust and the motor started working again. It was still working ten years later when I finally replaced the saw.

Re: Electric motor experts?

#6

Re: Electric motor experts?

Tim GC

>Wow, Spooky, I have a similar problem loud humming but no external capacitor, wiring goes to junction box mounted onto motor. All connections are clean and firmly attached. Please do not say burnt out starter coil ...

Re: Electric motor experts?

#7

Centrifugal Switch is stuck!

Jim Swank

>