Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Small warning on Nova Lathes.

Posts

Small warning on Nova Lathes.

#1

Small warning on Nova Lathes.

Barry Irby

>I have a Nova DVR that is about five years old. It's mounted on a flat butcher block type top on a cabinet. Sawdust builds up under and in the bed. I use my DC to clean up and yesterday I was poking my hand in between the ways to stir up the crud and get it moving. Turns out the edges of the casting down in between the ways are SHARP. I got a small cut between my fingers. Might want to file those sharp edges. Also it might be good to mount your lathe so that the bed doesn't trap crud.

PS. Other Nova lathes use the same beds.

Re: Small warning on Nova Lathes.

#2

Re: Small warning on Nova Lathes.

Carole Valentine

>Mine are already filed. DAMHIKT I use one of my back scratchers that I made to rake the shavings out. Looks to me like on the new ones, there is no opening at all beneath the ways. Maybe that sells more of the cast iron leg sets. I have been meaning to put mine on blocks but just haven't done it yet.

Re: Small warning on Nova Lathes.

#3

Re: Small warning on Nova Lathes.

Stuart Johnson

>I raised mine with 3/4" plywood blocks. I need to remake the top so I can add the extension and will probably double up the blocks. This will give a bit more room for chip removal plus I keep the tools I'm using under the lathe.

Re: Small warning on Nova Lathes.

#4

Mike Stafford

Re: Small warning on Nova Lathes.

Mike Stafford

>Yep, they sure are sharp. I also had to find out just how sharp the hard way...8( It was easier to file the sharp places if the bed ways are not bolted down.

Re: Small warning on Nova Lathes.

#5

Re: Small warning on Nova Lathes.

ET

>Lathes from the orient are particularly bad for sharp edges underneath. My General maxi has them all over, I think they are growing. Does anyone know what kind of a grinder I can use to make the job of grinding the sharp edges fast and easy. I used a small cut off wheel in a Dremel to smooth sharp edges on some other castings and that took a long time. ET

Re: Small warning on Nova Lathes.

#6

Re: Small warning on Nova Lathes.

Rick Allen

>A bastard file is often used.

That's a funny name for a file. Where did it get it's name? The answer I see at answerbag doesn't have any authority to it. That answer reminded me of "My Big Fat Greek Wedding" where every word is derived from Greek.

You can also use a 4 1/2" right angle grinder but that is difficult to get into some places.

Re: Small warning on Nova Lathes.

#7

Nova DVR Lathe Stand *LINK*

Fred Holder

>When I built the stand for my Nova DVR, I made the top of the out of two 2"x6" boards that were spaced apart to allow the shavings to fall through. I originally planned to install a slanted piece of plywood to channel the shavings out into a box. I wound up putting the plywood across the back of the stand for additional support and the shavings just fall down through the top of the stand. I have a box lid under the part closest to the headstock to catch most of the shavings. I simply remove it and dump is occasionaly.


Fred Holder's Domain Site