Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Stuck Lid

Posts

Stuck Lid

#1

Stuck Lid

Barbara Gill, Remlik VA

>Today I turned a nice little cherry box. I usually try not to have a lid fit too tight as having to use two hands to open a box is not user friendly. Today I miscalculated and the lid would not come off. I twisted and twisted. I knew about using a thin bladed knife but was afraid it would damage the wood. I tried the microwave, just warming the wood; that didn't work. So next I tried the refrigerator. The box stayed in for about 15-20 min. The lid twisted off! Now to get some sandpaper and carefully sand so the fit is better.

Re: Stuck Lid

#2

Glad you got it off undamaged.

Gil Jones on Lake Seminole GA

>Next time you might check with Ruth about serious "stuck stuff" removal tools ☻

Gil

Re: Stuck Lid

#3

Re: Glad you got it off undamaged.

Barbara Gill, Remlik VA

>Heck she bent a pipe wrench; what would she do with wood?

Re: Stuck Lid

#4

Re: Stuck Lid

Ed Moore

>Barbara, always make the female part first. Usually that is the lid. Don't final fit the tenon (male part) until last. At that point the lid should be cooled after sanding and friction finishing.

Sometimes we sand the lid and fit the tenon too soon thereafter. When the lid cools the fit is much tighter than we intended.

Ed

Re: Stuck Lid

#5

Grin ☺

Gil Jones on Lake Seminole GA

>

Re: Stuck Lid

#6

I Did :-)

Barbara Gill, Remlik VA

>

Re: Stuck Lid

#7

Re: Stuck Lid

DickAnderson

>I've had that happen with eucalyptus box lids, but the cause was deformation. Originally the lid had a good fit and either the wood was not bone dry or atmospheric changes over a couple weeks caused the lid to be bound very tight. My solution was to put the lidded box in the freezer overnight. Still took a little persuasion and then light sanding to make a proper fit. One box was tempermental and required two incarcerations in the freezer.