Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

myford lathe question

Posts

myford lathe question

#1

myford lathe question

joaz

>Hi all, I was recently given an M8 Myford lathe still in the grease.

I didn't get a manual and need to know the spindle thread size.

I am guessing 1"x 12 but not sure. Also, need to know if the spindle and tail take 1 morse taper. This thing is really old school. It came with a dead center for the tail stock. What?? I am not sure how that is suppose to work!

Its in perfect shape...made in 1980..the grey one. It was purchased from Zimmerman in Vermont. You old schoolers might remember him.

1/2 horse.The bed is a tube sort of like the old shopmates. I'm thinking about using it to replace my Mercury mini.

Anyway, any information would be much appreciated. Thanks Joaz

Re: myford lathe question

#2

Re: myford lathe question *LINK*

E.T.

>Robert Rosand used to or still has one of these lathes. He demos on it in his first video. Robert would probably answer all your questions and give you some pointers for setting it up. Here is a link to his site below. My impression was it to be a well built, British machine. Accurate machine work where it counted. Do not confuse it with the Sears and HD monotube crap lathes. ET


http://www.rrosand.com/index.html

Re: myford lathe question

#3

Re: myford lathe question

adrien

>It's a great little lathe. Was my first one, bought after a weekend with Russ. Used beeswax on the dead center and it worked. You might check if Russ still has the working sketch for setting up a solid plywood base. Mine was two layers of 3/4" plywood for a top on plywood sides and back that were bolted to a cement floor in my home's basement. I did a lot of turning off the left side of the lathe and at one time, instead of using the lathe's tool rest, set one up on a pipe in a 5 gallon can of cement and was able to turn a 23" bowl. Not bad for a lathe with a 9" swing. (P.S. had to change underwear after that bowl!)

Re: myford lathe question

#4

Re: myford lathe question *LINK*

DickL

>You can find Russ Zimmerman here.


Russ's web page

Re: myford lathe question

#5

Re: myford lathe question *LINK*

John Peck

>Here's another link with info about the Myford ML-8: http://www.lathes.co.uk/myfordwood/index.html


http://www.lathes.co.uk/myfordwood/index.html

Re: myford lathe question

#6

Re: myford lathe question

wilbur

>I can't claim to be an expert, but most Myford lathes use a 1" x 12 tpi spindle.

I have a Walker Turner lathe, which has a 1" x 12 tpi spindle as well, so I have looked for sources for accessories to fit this spindle. Myford was one of the lathes that popped up when I was searching. Some of the Grizzly lathes also use this spindle size.

Re: myford lathe question

#7

Re: myford lathe question

joaz

>Thanks all. I am going to try and get an insert for my Stronghold from Packard. I will post a pic. when I have it set up.

Thanks again. Joaz