Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Am I the only one?

Posts

Am I the only one?

#1

Am I the only one?

eliot d

>I heard and read about different ways to turn off that peak that forms at the bottom of a hollow form. I often reverse the direction of the lathe and approach it from the RIGHT side, i.e. from right to left, using a swan neck turning tool. Works great for me without much risk of flipping around and ruining the piece.

Re: Am I the only one?

#2

Re: Am I the only one?

George Van

>Thanks, I neverheard of that one Eliot, I will give it a try shortly!

Re: Am I the only one?

#3

Re: Am I the only one?

john lucas

>I haven't tried that. I always start just below the nub and then raise the tool up over it. This seems to work with scrapers or bowl gouges. I will have to try the reverse on my next vessel.

Re: Am I the only one?

#4

Re: Am I the only one?

eliot d

>Let me know it it works.

Re: Am I the only one?

#5

Re: Am I the only one?

Barry Irby

>Elliot, I have been playing with my Jamieson Captive bar system. I tried your idea on the first vessel I use it on and it worked great. I tried it with the tool dead center vertically and a 3/16" scraper. Could not make it work going forward. Switched to the Hunter cutter and ran the lathe backwards and it sniped it right off. Since that cutter won't cut going straight ahead, I just press it to the bottom to the rear of the nub and swung it forward. Worked great. Thanks.

Re: Am I the only one?

#6

Re: Am I the only one?

eliot d

>I happy that the method worked for you. I sometimes find that it's the only thing that works.