This is my homemade buffing system. On the shaft is the Carnauba Wheel.
The shaft is lengthened with a 5/8 Arbor with left handed threads. My friend ordered it for me from Grainger. It's called "Motor Arbor, 5/8 Left, Long". You'd need a 1/2" if your motor has a half-inch shaft.
Keeps me away from the table when I'm buffing a large piece.
>clockwise, looking at it from the shaft end, you need Left Handed threads on your arbor. If it's counter-clockwise rotation, Right Hand threads.
I'm going to put a short piece of 3/4" water-pipe foam insulation and tape around the arbor shaft. Then I can stop it by hand, to change wheels.
I've just finished rigging a sharpening and buffing system for my VL 100, so I don't have to carry a lot of extra stuff when I turn away from my shop. It's perfect! I'll post some pics in a day or two, after I get all my stuff unloaded and put away after the craft show yesterday. (It rained most of the day today, and then I worked a bad accident from 5:30 to 10:PM tonight.)