Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Turning Brass 360

Posts

Turning Brass 360

#1

Turning Brass 360

dwr

>A quick update from the previous posts regarding the grind on my gouges. Thanks to Wally, Jamie and the rest, I was able to regrind the small "hump" from the wings and it worked great.

Now I have some other questions.

I cut the Ash handles off my Thompson tools because they were too light for my taste. I am making some Aluminum handles to fill with shot. I want to do all the work on my wood lathes and know I can turn the Aluminum, However, I also want to turn some "Brass 360" and could not find anything in the archives. Brass is supposed to be soft and I think I can take it slow and have a go at it.

For you metalworkers: Is the Brass 360 alloy soft enough for turning on my spindle lathe? (I have several HSS tool bits I can rig up as well.) What RPM would you recommend I set my VFD for?

Thanks... looking forward to posting the new handles... if all goes well...;)

Dave

Re: Turning Brass 360

#2

Re: Turning Brass 360

Brian Hahn in SW Wisconsin

>I'm not familiar with Brass 360, but I have turned both brass and mild steel on my wood lathes. I used standard HSS scrapers and ran in the 300 rpm range.

Re: Turning Brass 360

#3

Re: Turning Brass 360

john lucas

>I'm not familiar with Brass 360 either. Just try to turn it. If it's too hard heat it up to red hot and then quench in water. That will anneal it so you can turn it. I use spindle gouges mostly to turn brass but any HSS tool will work.

Re: Turning Brass 360

#4

Steven Antonucci

You can turn brass

steve antonucci

>But it's a big mess, with a million little metal shavings everywhere. Don't use a bare hand to brush off the lathe ways, or you'll get 10,000 little brass splinters in your hand (DAMHIKT)

I laid a plastic bag over the ways to help contain the brass shavings. Worked somewhat, but you'll still have metal everywhere for a long time.

Steve

Re: Turning Brass 360

#5

Thanks guys...

dwr

>... will try Brass or Mild Steel.

Dave

Re: Turning Brass 360

#6

Steve...

dwr

>... have you tried mild steel using HSS bits?

Dave

Re: Turning Brass 360

#7

Steven Antonucci

just drilling holes

steve antonucci

>I actually turned copper and brass with a Sorby gouge (HSS) to dimension, but I've only tried drilling steel once along the length on the lathe. Results weren't much better than hand drilling in a vise, but 3 times as messy, so I don't chuck steel any more.

Steve